|
| markr154 |
|
|||
|
Hey guys,
Looking at getting a set of Pedders front lowering springs off a mate. He can't confirm whether they're Lows or Superlows ...but he tells me that the heights from top to bottom of each UNLOADED spring are 330mm and 338mm respectively. Said they dropped his Falcon about 2-3 inches from stock. The 338mm spring is the LH spring, and the extra height is to allow for engine torque. Can anyone here confirm whether they are Lows or Superlows from these measurements? Need answer quite URGENTLY! Cheers 
BTW - I've got Pedders short front struts with superlows in the front, and I'm sitting a little too low now ...so I'm hoping these springs will be Lows only ...and that they will fit in my short struts!
_________________ Hot Chilli Red EL XR6, 5-spd, JMM DEV 5 enhanced (161 rwkw custom tuned), Eliminator Switch Chip, 18" BA GTP rims, Pedders Superlows, BA XR6 badges, BA Sunroof, Pioneer Stereo, Splits, 6x9's, 10" sub, 700W 6-ch Viper amp.
|
|||
| Top | |
|||
| joolz |
|
|||
|
No such thing as left and right on the front springs only on the rears. They do sound like super lows as lows will drop around 30 mm and supers around 50-60mm.
|
|||
| Top | |
|||
| xf_xr6 |
|
||
|
If you can give me a part number, usually a 4 digit number on a bit of tape hanging of a coil and should start with 2, i'll be able to tell you
|
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 54 guests |
