|
michael1045 |
|
||
|
almost finished my manual conversion but cant get the gearbox onto the
bellhousing right there is like a 10mm gap i used a clutch alignment tool when i put the clutch in i had a look inside the bellhousing but cant see anything tha would stop the box going in has anyone else had this problem before |
||
Top | |
Krytox |
|
|||
|
Just keep wiggling and pushing, may even help to put it in gear and slap in the tailshaft yolk this way you can turn it a little.
But 10mm tells me the spline is in, but spigot is fouling. I've never had any problems with T5's going into position, maybe cos I use a spare input shaft to set it up. You have to remember the clutch plate will drop a bit when you use any tool, I always lift it a little as i tighten the plate up.
_________________ Carefree, we may not be number one, but we're up there. |
|||
Top | |
ilovmel |
|
||
|
i agrree with the last guy wiggle it and put it into gear and then get some one to turn the shaft from the back
_________________ i am in need of a new front bar or good condation secondhand for a 95 ef futra,
|
||
Top | |
michael1045 |
|
||
|
got the box in and the car goes heaps beter
only problem now is when i went to plug in the manual loom i could not thin the rectangular plug in the engine bay a mates ef hase it but all that we could find in mine was this square box looking thing with a bolt through the middle and its got like 50 wires going to it has any body else noticed this or am i looking at the wrong plug its got that el hybrid engine in it |
||
Top | |
Gaz |
|
||
|
IIRC EL's did not have seperate plugs that suited manual and auto, just the one larger plug.
_________________ 2007 Steel BF Ghia MKII V8 - 19" GTP's + Superlows |
||
Top | |
old_mate |
|
|||
|
yup EL's dont have the connector. You will have to ground the start inhibit relay thing (sounds like you already have done) and wire in the reverse lights. I just taped all the spare connectors for the auto up out of the way. you might want to wire in the neutral switch too but i never bothered.
_________________ too many rabbits in china |
|||
Top | |
Froudey |
|
||
|
neutral switch what's the go with wireing this switch in what purpose does it serve
_________________ R.I.P Tobias my son. |
||
Top | |
old_mate |
|
|||
|
means the car wont turn over unless the clutch is engaged. i didnt worry about it, it means i can move the car off the starter if needed, or run into others when starting the car in gear when not paying attention haha
_________________ too many rabbits in china |
|||
Top | |
michael1045 |
|
||
|
yea i got it running and everything
just didnt know that els did not have seperate plugs to the gearbox thanks |
||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 66 guests |