|
| Jinxed |
|
||
|
Hi hoping someone may be able to help me out, Was changing the Mrs Drive Axles today , drivers side came out easy.Passenger side will not budge, tried everything but it will not come out. I have an Haynes manual for it but it gives no breakdown of the Trans , I'm wondering if i would be able to knock it out through the drivers side , or if anyone has any ideas why it would be jammed.
Any help appreciated Cheers Jinxed |
||
| Top | |
||
| cjh |
|
|||
|
You can lever them out, use 2 levers with equal pressure either side of the inner CV joint. They are held in with a wire type circlip.
_________________ http://youtu.be/jJTh9F3Vgg0 |
|||
| Top | |
|||
| sexyr6 |
|
|||
|
yeah ive had this problem... you need to get an old extention bar and a hammer and place the extention ina position where the force of the hammer blow is pushing the shaft outwards... first give it a coule of good hits if it dosent move, rotate the shaft a 1/4 of a turn, if it doesnt move just keep rotating it untill it does.. part of my job is wrecking cars, so i get this alot this procedure tends to work for me...
|
|||
| Top | |
|||
| Jinxed |
|
||
|
thanks for the replies guys will have another crack at it in the morning and post the results.
Cheers Jinxed |
||
| Top | |
||
| EF Wagon |
|
|||
Posts: 69 Joined: 27th Dec 2006 Ride: EF Wagon Location: Canberra - not as bad as you think |
My missus has a 96 Festiva and I've found that simply pushing the driveshafts inwards first before you try and pop them out (do it real fast) works best.
Seems to help break the wire retainers away cleanly. A small pry bar and big flat blade screwdriver make ideal levers.
_________________ 96 EF Wagon, PRINS VSI LPG, Wade 1636, 4480's, Redback zorst, Metalcat, 3 angle valve job, .5mm overbore, hypertec pistons, shaved head (because the head was banana shaped when I brought it), Tickford 16" alloys, KYB shocks, 30mm sway bar, 1 1/2 degrees negative camber, tow bar, roof racks. |
|||
| Top | |
|||
| Jinxed |
|
||
|
{USERNAME} wrote: yeah ive had this problem... you need to get an old extention bar and a hammer and place the extention ina position where the force of the hammer blow is pushing the shaft outwards... first give it a coule of good hits if it dosent move, rotate the shaft a 1/4 of a turn, if it doesnt move just keep rotating it untill it does.. part of my job is wrecking cars, so i get this alot this procedure tends to work for me...
thanks mate your suggestion did the trick , 3 hits and it was out. Thanks heaps for your help 
Cheers Jinxed |
||
| Top | |
||
| Disco Frank |
|
|||
|
so u break the wire clips that hold the cv joint in?
use a set of circlip pliers! sheesh glad to hear u got it out mate ut now u need o get a new circlip!
_________________ RIP SCOTT |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 31 guests |
