|
Bsjenko |
|
|||
|
Howdy people. The clutch on the telstar (89 2.2ltr model) has finalyy s**t itself, so i shall be in need to be fixing it very shortly. But i have never looked into, pulled apart, or installed a clutch before.
So what i want to know is what is involved in replaceing one, is it a huge task? What actual parts will need replacing? what sort of prices should i be looking at? Pretty much stuff from the start, as i have never dealt with them before cheers BEN
_________________ The Lane Lives.... Finally!!!! |
|||
Top | |
Bsjenko |
|
|||
|
yello??
_________________ The Lane Lives.... Finally!!!! |
|||
Top | |
cjh |
|
|||
|
Its a fair size job, CV shafts will have to come out, so you will need to fill up the box again.
Have you got a workshop manual?????? Your gunna need it if you haven't done one before. There not that cheap, I think. Maybe around $200-$300 for a kit, then there's machining the flywheel. Good luck with it.
_________________ http://youtu.be/jJTh9F3Vgg0 |
|||
Top | |
mitchg911 |
|
|||
|
ive never worked on that car before but im assuming its similar to other front wheel drives,
drain the gearbox/diff, remove the front wheels, brake assembly remove the cv shafts remove the started motor, disconnect the gear linkages undo all the gearbox bolts and whatever else is holding the box in, remove gbox. take the pressure plate off the clutch, and remove the flywheel. the flywheel will probably need machining so get it done and reassembly is the same as dissasembly. make sure you align the clutch tho, make life much easier... as cjh said a workshop manual would be benificial, but if you use your head and keep everything organised you shouldnt have much trouble.. -mitch
_________________ BF XR6T 6spd Auto. 60lb injectors, Hybrid Cooler, Custom Piping, Custom Surge Tank, Actuator. |
|||
Top | |
cjh |
|
|||
|
If you do not machine the flywheel, the warranty on the clutch kit will be null & void. It is worth doing.
_________________ http://youtu.be/jJTh9F3Vgg0 |
|||
Top | |
Krytox |
|
|||
|
you'll also need to support the engine as the gearbox is part of the engine mount.
Usually you'll have a steel brace from both strut towers and a chain/rod setup.
_________________ Carefree, we may not be number one, but we're up there. |
|||
Top | |
fordcoupe |
|
|||
|
Must be a telstar week just did the box in my sons 2.2 telstar. Unless your clutch was doing weird things like pulsing or grabbing machining the fly wheel is not an issue. The removal is a right pain in the rear just watch out for the removal of the cv axles as they where hard to remove ( got some sort of circlip thing going on) and the guys are right about supporting the engine aswell. Its not a fun job to do>good luck
_________________ XC 396 Scat stroker |
|||
Top | |
Bsjenko |
|
|||
|
Hmmm thanks for the heads up people. Sounds like a mission and a half to do this bloody clutch.
What actual parts do i need to be replaceing?? http://cgi.ebay.com.au/FORD-TELSTAR-AT- ... dZViewItem Is that all i will need?
_________________ The Lane Lives.... Finally!!!! |
|||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 35 guests |