|
| christopher |
|
||
|
i have an eb series 2 my problem is the power steering shudders when turning at low revs and mainly when hot .Ive added a cooler to the steering but no better .My old ea did the same thing but not a bad and ideas
|
||
| Top | |
||
| v8fordman351 |
|
|||
|
you could try an oil change and use i think its called transtrac but allmost all fords do it its nothing to worrie about
|
|||
| Top | |
|||
| xpression |
|
|||
|
its called mobil 424... same as used in AU;'s
|
|||
| Top | |
|||
| Punnisher_42 |
|
|||
|
Sounds like loose or worn drive belt is slipping. This is something that happened to me. Just as you described low revs and as you turn the steering wheel, the power assistance cuts in and out.
Replaced the belt, and tightend it to the propper ammount and it works like a dream not.
_________________ Regards, |
|||
| Top | |
|||
| christopher |
|
||
|
i will try fresh oil and check the belt and cross my fingers thanks people
|
||
| Top | |
||
| ndroo |
|
||
|
not the belt...i replaced mine already
and its not the fluid....done that too..helped but didnt fix it in my el that has done 260,000kms its just started to happen...i think its just the pump has become old and is inefficient in its old age so it struggles a little. Either way, gona get 1 from the wreckers n see how i go. |
||
| Top | |
||
| needfordspeed |
|
||
|
I have the same problem in my current EA and the old one. Funny thing is it only started in both after a belt change, I tried loosening and tightening but it's still the same.
I was thinking it may be the tie rod ends? How do the tie rod ends affect your steering when they are stuffed? I'll keep my eyes on this thread in case someone figures out wth it is!
_________________ 1988 EA S-Pack|MPI|LSD|AIT turbo manifold|Garrett GT3540|3" Exhaust turbo back|Resprayed|microtech LT8s|60lb Injectors|Bosch 044 with surge tank|3000 RPM stall|Ported AU head|Wade turbo cam|Crow double valve springs|1.3mm MLS headgasket|C4 conversion|Built bottom end|10.6@125MPHi |
||
| Top | |
||
| christopher |
|
||
|
mines a eb 2 done 293.000 runs good but the steering is annoying .my old car ea was doing it we changed the pump and it helped alot but still there a little bit .A friend told me the fluid gets to hot and burns like transmission fluid does .Could this happen/
|
||
| Top | |
||
| opto |
|
|||
|
this is common with ea to ed mobil 424 is the start dont forget to turn the steering left and right a couple times to remove old fluid from power steering system.
Ford service says the two other solutions are to put an EF High pressure line and an adapter to suit. The other is Enzed can put a restrictor on the low pressure side. If this helps, May the Force Be with you...
_________________ I post here cos the russian tank driver doesn't |
|||
| Top | |
|||
| madmax |
|
|||
|
From Mobil's Web site the corect oil for a EA-EF Power steering is
MOBIL ATF or MOBIL ATF 220 For a EF ONLY they have added a comment " If power steering system is noisy, Ford recommend to flush system and refill with MOBILFLUID 424." This comment is NOT mentioned under EA-ED All models afer EF use MOBILFLUID 424.
_________________
|
|||
| Top | |
|||
| xpression |
|
|||
|
working at a ford dealer we've changed heaps of EA-ED's over to the mobil 424 and never had a problem...
|
|||
| Top | |
|||
| madmax |
|
|||
|
{USERNAME} wrote: working at a ford dealer we've changed heaps of EA-ED's over to the mobil 424 and never had a problem...
I wasn't sugesting there would be a problem, just quoting the site.
_________________
|
|||
| Top | |
|||
| xpression |
|
|||
|
wasnt trying to say u were
just clarifying that it does work |
|||
| Top | |
|||
| Bert |
|
||
|
If its shuddering at low engine speed I reckon it due to the pressure relief spring in the pump itself getting soft. I work on forklifts and when you set the relief too low the ram shudders under load.
|
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: Google [Bot] and 75 guests |
