I am doing my rear brakes and when I pulled the pin from the rear pistons I dropped the whole damn thing and I want to put it back together right. There is the piston, two thick washers with notches in them, a bolt for the worm drive and a metal shim, like a washer just very thin. Which order do they go into the piston?

Here's a diagram which might be helpful.

 

 

Attachments:

Brake diagram.jpg [ 39.9 KiB | Viewed 192 times ]

If its come apart that far, whats it look like inside???? That crud is all the way inside too.

 

 

Attachments:

ED Falcon brakes, dirty fluid etc. 001_resize.jpg [ 202.7 KiB | Viewed 159 times ]

ED Falcon brakes, dirty fluid etc. 006_resize.jpg [ 220.32 KiB | Viewed 148 times ]

ED Falcon brakes, dirty fluid etc. 005_resize.jpg [ 166.41 KiB | Viewed 183 times ]

ED Falcon brakes, dirty fluid etc. 004_resize.jpg [ 184.5 KiB | Viewed 151 times ]

If you are intending to refit it all back together.I suggest getting 2 rear caliper seal kits.I would also make sure you clean the caliper and the piston thoroughly.You can use alittle bit of steel wool to clean the outside of the piston and the inside of the caliper where the piston is housed.

When reassembling use either rubber grease or some new brake fluid as the lubricant for the seals.