|
Bud_and_Lynn |
|
|||
|
Hi guys and gals.
As some of you would know I have recently put an EL box into my AU. Going good apart from a bit of a clunk when it goes from first to second. My new problem is kinda strange. I was driving to work today, cruise control on doing 100k and all of a sudden the speedo went nuts. Almost seemed to be bouncing from 0 to 140 on the clock. When I got off the freeway and slowed to 60 it was fine. Then I hit an 80 zone and it did it again. Bouncing from about 15 to 110 this time, then coming back to normal once I hit the 60 zone. When I left work at 10:30 I was waiting for the entertainment again but it didn't do it. I assume the speedo is electronic due to the fact that I didn't fit a speedo cable when I put the box in. Any ideas from you legends out there that are always able to help me with my dramas. I thank you all in advance cos I know someone has had the same problem and will be able to help me. Later peoples
_________________ LONG LIVE THE BEAR |
|||
Top | |
XRfairmont67 |
|
|||
|
u can put your old au sender unit into the new el box
its only 1 bolt that holds it in, passenger side rear of trans.(usually a red cover over the wiring) |
|||
Top | |
Sommers NL |
|
|||
|
+1 for speedo sensor, common problem, my NL does it sometimes, will replaced sender next time i put my car on hoist at work ..
_________________ BANNED!!!! |
|||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 69 guests |