|
| mendyxr6 |
|
|||
|
any easy ways on how to remove it????
_________________ kangaroos and radiators are a bad mixture |
|||
| Top | |
|||
| twase |
|
|||
|
Get a dowel or bolt that just fits in the bearing then fill the bearing up with grease then use the bolt/dowel as a piston to force the bearing out by taping it with a hammer.
_________________ BF Fairmont Ghia Series II update. |
|||
| Top | |
|||
| mendyxr6 |
|
|||
|
ah yes tried thats 1 and got no were at all
_________________ kangaroos and radiators are a bad mixture |
|||
| Top | |
|||
| twase |
|
|||
|
Thicker grease and more of it and really sharp blows.
_________________ BF Fairmont Ghia Series II update. |
|||
| Top | |
|||
| twase |
|
|||
|
Just noticed your other thread you are wanting to put a Auto behind it, do you realy need to remove it?
_________________ BF Fairmont Ghia Series II update. |
|||
| Top | |
|||
| mendyxr6 |
|
|||
|
i sure do as where the spigot sits there is a bit on the torque converter that does in to there. so it sits in properly. i tried yelling at it, spitting on it and punching too but they didnt work either
_________________ kangaroos and radiators are a bad mixture |
|||
| Top | |
|||
| ELGT |
|
|||
|
You need to find a drift exactly the same size as the ID of the spigot bearing.
A 1/2 ext bar, with some duct tape will work. Bearing grease 3/4 fill the spigot hole, and try to drive the ext bar in. Keep trying, and if grease comes out past the ext bar, more duct tape. |
|||
| Top | |
|||
| bluecube |
|
|||
|
i've removed them before by sticking a long extension in there and gradually wiggling out the bearing by smashing the side of the extension with a hammer. takes fukin ages but it works (totally destroys the bearing tho but who cares)
_________________ Sold my EB |
|||
| Top | |
|||
| JCaSs |
|
||
|
that should work, just make sure u get as much grease in there as possible. ive also her you can use wet paper/tissues, this might be better if the grease is forcing its way through the bearing, but that dont happen too often. good luck
_________________ EL GLi, DEV5 head, JMM race series extractors and exhaust.
|
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 84 guests |
