Just thought I’d post some pics of the strengthening I did to my pedal box (not sure if it’s anything new, but might help someone).

Basically added extra weld to the pin, also welded a plate on the back, then drilled and tapped a thread into the pin and made a bracket going to the top of the pedal box.

The aim was to give the pin another anchor point, rather than just one side.

 

 

Attachments:

DSC02270.JPG [ 99.94 KiB | Viewed 163 times ]

DSC02268.JPG [ 85.65 KiB | Viewed 160 times ]

any bit of info helps mate, i'm sure someone will see it and use it.


the pic i've uploaded is previous to having touched it, i dont have any after pics, which is a shame.

but, with mine, i bent it back to shape, welded it, grinded it back and made up a piece of flat 6mm iron, and grinded out the link bit and shaped it to suit.
i then drilled a couple of extra holes, welded them, and also right around the iron plate, and to date i have not had a problem.
[/img]

 

 

Attachments:

pedal box.JPG [ 101.77 KiB | Viewed 161 times ]

Yeah, twin point attachements are way better.