|
| frankie |
|
||
|
Has anybody experianced a loud clunk/grawnch from the frount end of their car - particullay under breaking and cornering. Everything that moves has been replaced - bushes, ball joints, tie rods , roters, pads, brgs, springs , shocks - three workshops unable to find, including local Ford Franchise - any ideas?
|
||
| Top | |
||
| Daniel |
|
|||
|
Not too sure, sounds like youve covered almost the lot lol!
Only thing i can say is there was a recall on el's to do with clunks when cornering/braking, often heard while entering driveways, ill see if i can find a bit of info later on. 
_________________ BF Typhoon, Dejavu - 6sp Auto, Leather, Sunroof, 19"s, Electric Pedals, Tint, FPV Sports Wheel, FPV Mats. |
|||
| Top | |
|||
| Daniel |
|
|||
|
Just had a read of the doco, it says for the recall i had in mind is more of a knock, so sounds like i was going down the wrong road..
Someone should have some idea tho, dont stress. 
_________________ BF Typhoon, Dejavu - 6sp Auto, Leather, Sunroof, 19"s, Electric Pedals, Tint, FPV Sports Wheel, FPV Mats. |
|||
| Top | |
|||
| One Drone |
|
|||
|
Make sure everything is torqued up properly.. Especially the bolts that attach the camber kit to the arms.
_________________ There are 10 types of people in this world. |
|||
| Top | |
|||
| frankie |
|
||
|
I have had all bolts tightened as tight as I can get them - I'm at a bit of a loss - I would be interested to read about that recall! The clunk is especially bad when you enter driveways as you mentioned
|
||
| Top | |
||
| fairmont1998 |
|
|||
|
Me too. My car isn't making any noises but I didn't know there was a recall on the ELs. I'm interested to read about it.
_________________ 2008 WQ Fiesta XR4 |
|||
| Top | |
|||
| frankie |
|
||
|
a side issue - was there only 222 EL V8 Fairmonts made? (just reading your message below your replys) Was this only in Aussy or did New Zealand have some more? - Just curios.
|
||
| Top | |
||
| e-falcon |
|
||
|
WOW- I'm not the only poor bastard with this problem! I have a EFII Fairmont that has the very same thing. It happens mainly under heavy braking, driveways & if I change from reverse to foward quickly (not the uni's, it's in the front end). It's a very heavy klunk that you can really feel under the floor. I too, have got new springs, shocks, Z bar bushes, upper & lower ball joints, wheel bearings and a wheel alignment. The guy's at two very well known suspension places don't know what it is. The place that did the wheel alignment said it aligned better than most EF & EL's. SOMEBODY- PLEASE HELP!!!!!!!
|
||
| Top | |
||
| fairmont1998 |
|
|||
|
frankie wrote: a side issue - was there only 222 EL V8 Fairmonts made? (just reading your message below your replys) Was this only in Aussy or did New Zealand have some more? - Just curios.
Yep, 222 is all that rolled off the line. Exports to NZ would have come out of that 222.
_________________ 2008 WQ Fiesta XR4 |
|||
| Top | |
|||
| Kit |
|
|||
|
Happened to me after I put my Pacemaker extractors on. At first I put it down to the steering shaft under the extractors being heat affected but probably completely 2 different things.
|
|||
| Top | |
|||
| frankie |
|
||
|
my headers are very close to the sway bar which with some design of headers may be a design fault. How ever I took my sway bar off altogether to see if this was the issue on my car - drove it around the block and the noise was still there?
Back to the drawing board! |
||
| Top | |
||
| AUIIXLS |
|
||
|
I know this thread is a few ys old, but did anyone find the cause of this knock while braking? I have an AU (hence the nic) with the same problem, so sounds like there might be a recall on it. Anyone know of one?
|
||
| Top | |
||
| eboost |
|
|||
|
i also have an el with the same knock. Happens when you go from drive to reverse and vice versa. Mainly LH sode
|
|||
| Top | |
|||
| AUIIXLS |
|
||
|
I dont get the knock switching from D to R. Just when stopping at slow speeds. Having it checked tomorrow (for Upper Ball Joint, Wheel Bearing (possibly needing tightening slightly), Caliper (read somewhere if shims can leave a gap and cause knock), and everything else associated with suspension). Suspension (struts and springs), new as of last year and all bushes look good and tight. Only leak I could see was from the upper ball joint I think it is called (on the upper swing arm). anyway, update here when I know more.
|
||
| Top | |
||
| Sturmovik |
|
|||
|
Engine mounts
_________________ 1993 ED XR6 5speed Polynesian Green. Project car. |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 105 guests |
