|
| phongus |
|
|||
|
Hey everyone. Bought an alloy tailshaft not long ago and it is just sitting in my garage...it is however starting to form some rust on the end which goes into the output shaft of the transmission...how do I go about removing this rust, is it necessary to do so?
phong =P~
_________________ phongus = Post whore 2006 |
|||
| Top | |
|||
| Damo |
|
|||
|
just use one of those Jex pad things mums use is the kitchen, like the wirey kinda stuff. Either that or some fine sand paper will fix it up.
|
|||
| Top | |
|||
| phongus |
|
|||
|
ohhh...well i thought I had to remove the rust and then put something on it or something.
phong =P~
_________________ phongus = Post whore 2006 |
|||
| Top | |
|||
| kwaussiekid |
|
||
|
Clean it up then coat in oil to protect --or better still-instal !!
_________________ The older I get the better I was! |
||
| Top | |
||
| Damo |
|
|||
|
well you could probably put some trans oil or greese on it's just gunna sit around, probably stop it from rusting again. Personally I wouldn't bother.
|
|||
| Top | |
|||
| phongus |
|
|||
|
hehehe, yeah kwaussiekid. might remove the rust and install it straight after...but no time to do it at the moment.
thanks ya'll.. phong =P~
_________________ phongus = Post whore 2006 |
|||
| Top | |
|||
| TwinturboBMX |
|
|||
|
Yeah get rid of it, keep the sucker clean. Just apply some lube oil or oil of some type just as a thin film to prevent rust, works a charm. Just try not to get dirt in the oil.
_________________ 17" Tezza Steelies, King F**king lows, pedders sports ryders, 2.5" cat back exhaust, pacemaker extractors, T5 manual
|
|||
| Top | |
|||
| joolz |
|
|||
|
Just use a scotch pad (scouring pad) dont rub it along the slip flange (rub around it) Spray it with some WD-40 or similar. The very worst it can do is chew out the extension casing seal on the trans if not a clean smooth surface.
|
|||
| Top | |
|||
| snap0964 |
|
|||
|
And after you've cleaned it and applied oil, grease, etc, put a plastic bag over it and tape it up. Keeps dust, rubbish, etc off.
Then when you're ready to use it, you can remove the tape and bag.
_________________ 96 XH Longreach 'S': LPG, Alarm, 3.23:1 LSD, Cruise, Trip Comp, ABS, Power Windows, Mid Series Dome Lt, Climate Ctrl |
|||
| Top | |
|||
| Private9 |
|
|||
|
Can't believe it's started to rust so quickly! You only took it out a week or so ago!
|
|||
| Top | |
|||
| phongus |
|
|||
|
{USERNAME} wrote: Can't believe it's started to rust so quickly! You only took it out a week or so ago!
hehehe yeah. I should really put it in quick. Rust does react instantly  just depends how much.
Well thanks for all the help. Will use something to get rid of the rust, clean it with something non-rust causing, and then dip it in some oil and wrap it up with a plastic bag.
phong =P~
_________________ phongus = Post whore 2006 |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 49 guests |
