|
| ElwoodBlues |
|
||
|
Just wondering if manual and auto tailshaft's are the same.
I want to get a XR tailshaft for my Futura but its easier to find a auto 1 then a manual 1. Cheers
_________________ EF Futura factory 5 spd
|
||
| Top | |
||
| joolz |
|
|||
|
No the slip flanges are different, auto is 38.5 mm in daimater and the manual is 43.8 mm. I think the auto shaft is about 60 mm longer than the manual. Another big difference is the XR shaft is alloy and the futura is steel. Alloy can withstand alot higher speeds before imbalance may occur.
|
|||
| Top | |
|||
| ElwoodBlues |
|
||
|
{USERNAME} wrote: Another big difference is the XR shaft is alloy and the futura is steel. Alloy can withstand alot higher speeds before imbalance may occur.
Thats the reason I want to change the tailshaft, so when I am doing higher speeds I dont have to worry about it breaking
_________________ EF Futura factory 5 spd
|
||
| Top | |
||
| joolz |
|
|||
|
sorry didnt read the post properly! you shouldnt have a problem if they are both auto. Measure the shaft between the centres of the weld yoke eyes. if there is a diiference of only 10 mm it should be ok.
|
|||
| Top | |
|||
| XR8Chic |
|
|||
|
Instead of buying a 2nd hand (and possibly unbalanced) shaft - why not buy one from a place that makes them?
They are not that expensive, and you will have the peice of mind knowing its balanced, and the right size for your car. Mal Wood Automotive in QLD did mine for me (I got him to custom make me a 2 peice shaft).
_________________ 1993 ED XR8 - Poly Green |
|||
| Top | |
|||
| stockstandard |
|
|||
|
I used auto EF tailshaft in my manual EF with no problems.
I now use an alloy shaft from an auto EL XR8 in manual I6 EF and lengths are fine.
_________________ Stoke me a clipper, I'll be back for Christmas |
|||
| Top | |
|||
| ElwoodBlues |
|
||
|
{USERNAME} wrote: Instead of buying a 2nd hand (and possibly unbalanced) shaft - why not buy one from a place that makes them?
They are not that expensive, and you will have the peice of mind knowing its balanced, and the right size for your car. Mal Wood Automotive in QLD did mine for me (I got him to custom make me a 2 peice shaft). If you dont mind me asking how much did it cost to get 1 custom made.
_________________ EF Futura factory 5 spd
|
||
| Top | |
||
| joolz |
|
|||
|
Sorry its only the V8 manuals that have the larger slip flange.
A 2 piece shaft will have to have a cardin joint on the rear instead of a CV unless the diff flange is replaced. Also the centre bearing mounting height is crucial otherwise on the initial spin the mid section of the shaft will wobble. I would go for the alloy shaft as a 2 pce is involved and costly for no real benifit. |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 37 guests |
