|
| Coreys0 |
|
||
|
Is it worth getting a transmission cooler for my ba xr6?? If so is it to run in a partnership with the one in the radiator or seperate?
Cheers Corey |
||
| Top | |
||
| kwaussiekid |
|
||
|
Do away with the in-radiator one and run the outside one independently.if yours hasn't already been fixed-BAs had issues with transmission coolers letting water into them and wrecking the trans,then you will be safer also!
_________________ The older I get the better I was! |
||
| Top | |
||
| Coreys0 |
|
||
|
Will it be as effective as the water cooled one?
|
||
| Top | |
||
| kwaussiekid |
|
||
|
I believe it will be better,so do other manufacturers.
_________________ The older I get the better I was! |
||
| Top | |
||
| Coreys0 |
|
||
|
you wouldnt know a brand off the top of your head?
Cheers Corey |
||
| Top | |
||
| kwaussiekid |
|
||
|
No,but if you emailed FTG,I am sure they will have a few available.
_________________ The older I get the better I was! |
||
| Top | |
||
| phil545 |
|
|||
|
PWR make a BA specific cooler which is setup to bypass the in radiator standard one. All most a must have for all BA owners. The BFs were a little better and used a heater exchange which attaches to the side of the block on the passenger side (best seen when the car is up on a hoist)
_________________ I hate arriving at my destination as then I have to get out of my car! |
|||
| Top | |
|||
| TROYMAN |
|
||
|
just dont get one thats to large like i did, i got a 300x300 cooler and ran it without the radiator cooler and found the trans was not warming up and was not allowing the torque converter to lock up unless i had driven more than an hour due to the trans being to cold..
i now run it through both and no more problems.. if you dont drive on the freeway you wont notice it.. |
||
| Top | |
||
| cjh |
|
||||||||
|
phil545 wrote: PWR make a BA specific cooler which is setup to bypass the in radiator standard one. All most a must have for all BA owners. The BFs were a little better and used a heater exchange which attaches to the side of the block on the passenger side (best seen when the car is up on a hoist) Here is some pics of what they look like...although this is a 6sp auto....it has coolant hoses running from up the front to the back for the cooler....and has it's own t'stat too....made by KTM, too.... 
_________________ http://youtu.be/jJTh9F3Vgg0 |
||||||||
| Top | |
||||||||
| phil545 |
|
|||
|
Yeah mine is the same even with the 4sp. I took some pics of mine in my thread when we replaced it recently. Put in the turbo territory one which are known for being more durable so hopefully be all sweet for the next 100 odd kms
_________________ I hate arriving at my destination as then I have to get out of my car! |
|||
| Top | |
|||
| low_ryda |
|
|||
|
point is, which troyman even proved, a heat exchanger in line with a cooler is a good idea. Then in theory the system works more like a regulated radiator system providing constant temp trans fluid no matter what conditions.
Problem is the factory radiator.. I'm sure a good quality aftermarket unit would be fine for more kms. I got told those ktm heat exchangers have been known to fail to but not as often as ba radiators. Everythings got a lifespan. Unfortunately late model car part lifespans are diminishing in general.
_________________ Not to get technical, but according to chemistry alcohol is a solution. |
|||
| Top | |
|||
| phil545 |
|
|||
|
Exactly right mate, which is why i just replaced my exchange for paranoia that it was going to fail
_________________ I hate arriving at my destination as then I have to get out of my car! |
|||
| Top | |
|||
| cjh |
|
|||
|
I as looking at a BF XR6 MkII yesterday on a hoist.....6sp auto.....has a metal pan on the tranny and NO visible t'stat for the auto fluid heat exchanger......?????
_________________ http://youtu.be/jJTh9F3Vgg0 |
|||
| Top | |
|||
| low_ryda |
|
|||
|
I'm pretty sure fords fix for the leaking plastic thermostat housing was to delete the thermostat... as the coolant is already regulated coming from the engine thermostat anyway.
_________________ Not to get technical, but according to chemistry alcohol is a solution. |
|||
| Top | |
|||
| Coreys0 |
|
||
|
so do all transmission coolers mount there... and i was thinking of completely removing the radiator one... ie. capping it off and only running the aftermarket
|
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 49 guests |
