|
Disco Frank |
|
|||
|
TROYMAN wrote: so the wheels are centralized buy the nuts only, same as per most aftermarket rims they have a larger bore than the hub.. wondering if the op is using the correct wheel nuts? maybe they are not deep enough to mount the rim to the hub? or they dont have the the right taper on them to fit into the wheel rim hole?
_________________ RIP SCOTT |
|||
Top | |
ranga83 |
|
||
|
dammit frank! my missus was watching then, just copped a whack to the back of the head!
_________________ ef futura, pacemakers, 2.5inch catback, k&n panel filter and 3.45 lsd. extractors/cat, ticky head, custom cam grind, t5. now onto cosmetics. |
||
Top | |
SWC |
|
||
|
I was wondering the same thing Frank.
|
||
Top | |
Lumpy20 |
|
||
|
Yep, wheel nuts were a part of a very complex issue. Someone replaced the original Ford shank mag wheel nuts with steel rim nuts. I suspect, but cannot confirm, that this was done to try and reduce the vibration. The original wheel nuts have a smaller taper section but a shank that helps line up the rim on the hub spigot. If you read the OP above you will see that the rims were redone, with new profile inserts (to match the new OEM wheel nuts), and a set of original Ford wheel nuts will be used on the OEM front hubs. Regards, KH
|
||
Top | |
SWC |
|
||
|
EF/EL alloy wheel nuts have no shank on them, they are a tapered end to match the taper in the rim.
|
||
Top | |
Lumpy20 |
|
||
|
Wrong. Original OEM NL Fairlane wheel nuts are black (call your local Ford dealer) and have a different part number to steel rim nuts. Anyway I am tired of all this nonsense. Will not post any more replies. My thanks to those who have engaged in the discussion and found it helpful. Regards, KH
|
||
Top | |
Disco Frank |
|
|||
|
ranga83 wrote: dammit frank! my missus was watching then, just copped a whack to the back of the head! turn off signatures then.....
_________________ RIP SCOTT |
|||
Top | |
Disco Frank |
|
|||
|
actually
just had a thought being a gay assed e series could the wheel bearings not have been tensioned up correctly when the new hubs where fitted? loose wheel bearings will cause all sorts of vibrations through the steering
_________________ RIP SCOTT |
|||
Top | |
Lowlane7 |
|
||
|
Disco Frank wrote: ranga83 wrote: dammit frank! my missus was watching then, just copped a whack to the back of the head! turn off signatures then..... BUT ITS JUST SO MESMERIZING!!!!!!!!!!!!!!!!!!! ![]() ![]() ![]() EDIT: E series are as gay assed as your sig is...... NOT AT ALL!
_________________ [color=#004080]Cheers, Jacob. |
||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 33 guests |