Ok i have an EB series 1 fairmont, with an EL conversion. Ive built a shift kit as in the DIY thread, i am up to wiring it up to the ecu but have run into a prob. I have the red pin 57 (or 71 EF equivalent) wire but i dont have the green 38 (81) wire in my EB1 loom, which im supposed to cut as in the diagram.

If any one put a shift kit in an EA - ED falcon and it works can you help me please.

Im very confused as im not great with electronics.

I would put wire in 38 pin and run wire 2 off it to 5.6Ohm resistor thats OK with me, but what do i wire up wire 3 to?, there is no 38 loom side wire to wire it to?

If anyone could help it would be fantastic

Sorry to keep bringing up shiftkit stuff but im STUCK

 

 

Attachments:

ecu.jpg [ 18.68 KiB | Viewed 758 times ]

shiftkitdiagram3wf.23232323.png [ 11.69 KiB | Viewed 758 times ]