|
| 6mitcho9 |
|
||
|
Dont forget Flex Plate/Torque Converter
Are the boxes the same length? Just curious for tailshaft length reasons |
||
| Top | |
||
| kurtlives11 |
|
||
|
just keep the manual lol man id kill to have a 5 speed in my EB2
|
||
| Top | |
||
| altedxr6 |
|
|||
|
{USERNAME} wrote: Dont forget Flex Plate/Torque Converter
Are the boxes the same length? Just curious for tailshaft length reasons Yeah, Boxes are just about the same length .. maybe 1-2mm out .. but thats it .. |
|||
| Top | |
|||
| carnut1100 |
|
||
|
The bolts that hold the flex plate on are shorter than the flywheel bolts, and you will need to remove the spigot bearing. I put a motor out of a manual into an auto car and I had no end of trouble getting the spigot out. Ended up welding a bolt into it and using a jemmy bar.
_________________ I hate Hyundais. |
||
| Top | |
||
| altedxr6 |
|
|||
|
{USERNAME} wrote: The bolts that hold the flex plate on are shorter than the flywheel bolts, and you will need to remove the spigot bearing. I put a motor out of a manual into an auto car and I had no end of trouble getting the spigot out. Ended up welding a bolt into it and using a jemmy bar.
yeah, been there, done that, you knock some grease into the spigot bush bearing hole, and use a socket to push the grease into the spigot bush hole. and the grease pushes the spigot bush out 
|
|||
| Top | |
|||
| carnut1100 |
|
||
|
In theory, doesn't always work though. I tried that for hours and got the sh*ts with it and wheeled out the welder.
_________________ I hate Hyundais. |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 58 guests |
