|
| Mac Winter 76XB351GS |
|
|||
|
Gday,
I am doing a C4 to Toploader conversion in mt XB. I need to get hold of a hydraulic clutch set up. Does anyone know of somewhere I can get one from? Thanks, Matt
_________________ 76XBGS, 383c, custom crow cam, 4V p&p heads, Isky SS Valve+springs, extractors, 2.5"twins, MSD Ignition, Edelbrock intake, Forged bottom end, Barry Grant 750DP, thermo, discs, toploader, Holley fuel pump, SUPERCHARGED! |
|||
| Top | |
|||
| raiki |
|
|||
|
You can get basically everything from any of the auto stores. I bought a brand new Master and Slave cylinder from AutoPro. You will be able to get the clutch and pressure plate from there also.
Xclutch do a flywheel that is suitable, the same as I have in the 5.0L but you'll use the smaller counter weight for a cleveland (I think). It's there Billet one piece chrome/moly unit. It doesn't have the ring gear shrunk on, they are machined into the solid steel flywheel. I assume you already have the box and the bell housing. I bought a pedal direct from Ford, but that was a couple of years ago and at that point it was about to become a discontinued item. The only think I am not sure of is the clutch fork, but ring any clutch mob and they'll tell you. Not sure where you'll go in Tas, but I used Adelaide Clutch Service as they are the Xclutch dealer here.
_________________ Adrian
|
|||
| Top | |
|||
| Mac Winter 76XB351GS |
|
|||
|
Thanks for that.
I already have a clutch fork, gearbox, bellhousing, flywheel, and pedal box. I have an 11" Exceedy Sports organic clutch kit on order. I'll try and get hold of AutoPro tomorrow, dont have any in Tas as far as I know. Cheers, Matt
_________________ 76XBGS, 383c, custom crow cam, 4V p&p heads, Isky SS Valve+springs, extractors, 2.5"twins, MSD Ignition, Edelbrock intake, Forged bottom end, Barry Grant 750DP, thermo, discs, toploader, Holley fuel pump, SUPERCHARGED! |
|||
| Top | |
|||
| Mac Winter 76XB351GS |
|
|||
|
Repco fixed me up with 2 new cyls today and I have a secondhand setup coming from ebay. For some reason I didnt think that they would sell the cylinders themselves...good ol Repco.
Thanks for the help raiki
_________________ 76XBGS, 383c, custom crow cam, 4V p&p heads, Isky SS Valve+springs, extractors, 2.5"twins, MSD Ignition, Edelbrock intake, Forged bottom end, Barry Grant 750DP, thermo, discs, toploader, Holley fuel pump, SUPERCHARGED! |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 75 guests |
