|
| falcon_3512003 |
|
|||
|
can someone tell me why my pedal nily goes to the floor when i use breaks iv replaced breaks break boster blead the, system and still dose it its done it since iv had the car but i dont like that much travel in the pedal?
_________________ now have a series 1 au starting the mods slowly |
|||
| Top | |
|||
| madeaspack |
|
||
|
id say its not bled properly,or the master cylinder is shot
_________________ 97 el xr6,5 speed short shifter,sequential scoop,no arial,freshly resprayed,low on 17's,3 inch zorst,stainless hi flo cat,snort stage 3 stainless manifold,garrett t04e,front mount cooler,wolf 3d ecu,seimens 760cc injectors,walbro fuel pump |
||
| Top | |
||
| madeaspack |
|
||
|
it seemed to me to be to just be poor spelling,break is no shorter than brake so its pointless to say 'break' over brake,but meh...i understood it
_________________ 97 el xr6,5 speed short shifter,sequential scoop,no arial,freshly resprayed,low on 17's,3 inch zorst,stainless hi flo cat,snort stage 3 stainless manifold,garrett t04e,front mount cooler,wolf 3d ecu,seimens 760cc injectors,walbro fuel pump |
||
| Top | |
||
| falcon_3512003 |
|
|||
|
i dont realy care for spelling im not that up my self you can gather what im on about and the brakes are bled proper was done 3 times
_________________ now have a series 1 au starting the mods slowly |
|||
| Top | |
|||
| madeaspack |
|
||
|
then id say the master cylinder is buggered
_________________ 97 el xr6,5 speed short shifter,sequential scoop,no arial,freshly resprayed,low on 17's,3 inch zorst,stainless hi flo cat,snort stage 3 stainless manifold,garrett t04e,front mount cooler,wolf 3d ecu,seimens 760cc injectors,walbro fuel pump |
||
| Top | |
||
| kovac |
|
||
|
on my el when i bleed the brakes i didnt tighten the bleeders properly it was doing roughly the same thing maybe that
_________________ there is only 2 rules in driving go hard or go home |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 95 guests |
