|
| Felony |
|
|||
|
I have a prob and i think its my fuel pump on my 302, you put the foot in and it dies in the a** ( cuts out ), you back it off slowly and it will evetually get up there but it seems if you open the carb right up at once theres not enough fuel going in.....
_________________ Succesful trades with bentles_eb, Pane, chunkz, xr8_dismantler, OBS35N, mrnasty, Steady ED, voxace, Mash85, ovo616, ef biff, lukey, dazza2924, Seannyb, gunit18, jkk, Tocchi, |
|||
| Top | |
|||
| Interceptor |
|
||
|
what happens if you gradually put your foot down instead of just stomping on the accelerator?
_________________ Banned |
||
| Top | |
||
| Felony |
|
|||
|
it goes ok to a point then does the same thing, just pisses f@rt and cuts out.....
_________________ Succesful trades with bentles_eb, Pane, chunkz, xr8_dismantler, OBS35N, mrnasty, Steady ED, voxace, Mash85, ovo616, ef biff, lukey, dazza2924, Seannyb, gunit18, jkk, Tocchi, |
|||
| Top | |
|||
| Interceptor |
|
||
|
could be an accelerator pump, but if it does it as the revs get higher, i would suspect a clogged filter
is it the original carby, or a holley?
_________________ Banned |
||
| Top | |
||
| Felony |
|
|||
|
Of all things a quadrajet, choke assembly removed, and yeah its not much better at high rpms,
Cheers
_________________ Succesful trades with bentles_eb, Pane, chunkz, xr8_dismantler, OBS35N, mrnasty, Steady ED, voxace, Mash85, ovo616, ef biff, lukey, dazza2924, Seannyb, gunit18, jkk, Tocchi, |
|||
| Top | |
|||
| Interceptor |
|
||
|
nothing wrong with quadrajets if they're looked after
before doing anything drastic, replace the fuel filter that's screwed into the drivers side rear of the carby, and consider putting a carby kit through it
_________________ Banned |
||
| Top | |
||
| Felony |
|
|||
|
so you think it could be a carb prob rather than a fuel pump?
Cheers
_________________ Succesful trades with bentles_eb, Pane, chunkz, xr8_dismantler, OBS35N, mrnasty, Steady ED, voxace, Mash85, ovo616, ef biff, lukey, dazza2924, Seannyb, gunit18, jkk, Tocchi, |
|||
| Top | |
|||
| Felony |
|
|||
|
after playing with the pump and pulling the carb apart i would say the carb is beyond a kit, so i will be on the hunt for a holley
Cheers
_________________ Succesful trades with bentles_eb, Pane, chunkz, xr8_dismantler, OBS35N, mrnasty, Steady ED, voxace, Mash85, ovo616, ef biff, lukey, dazza2924, Seannyb, gunit18, jkk, Tocchi, |
|||
| Top | |
|||
| Interceptor |
|
||
|
why would you say the carb is beyond a kit? you didnt f**k it up putting it back together did you?
_________________ Banned |
||
| Top | |
||
| Felony |
|
|||
|
lol, no its the same as b4 the way it behaves and runs, i say i think its buggered cause inside it is a bit corroded, the float seems up the s**t and it doesnt seem to have an adjustment, fuel also pisses out the pump plunger top on the top of the carb, its also missing its choke setup, i think it could be better i just buy a holley
Cheers mate
_________________ Succesful trades with bentles_eb, Pane, chunkz, xr8_dismantler, OBS35N, mrnasty, Steady ED, voxace, Mash85, ovo616, ef biff, lukey, dazza2924, Seannyb, gunit18, jkk, Tocchi, |
|||
| Top | |
|||
| Interceptor |
|
||
|
btw, whats the thermoquad like?
_________________ Banned |
||
| Top | |
||
| Felony |
|
|||
|
looks like it has been sitting on a shelf for 20 years, hehehehe
Cheers
_________________ Succesful trades with bentles_eb, Pane, chunkz, xr8_dismantler, OBS35N, mrnasty, Steady ED, voxace, Mash85, ovo616, ef biff, lukey, dazza2924, Seannyb, gunit18, jkk, Tocchi, |
|||
| Top | |
|||
| Felony |
|
|||
|
I dont know wether or not to try it as its dusty and filty and would need a rebuild just to see how it went....
Cheers
_________________ Succesful trades with bentles_eb, Pane, chunkz, xr8_dismantler, OBS35N, mrnasty, Steady ED, voxace, Mash85, ovo616, ef biff, lukey, dazza2924, Seannyb, gunit18, jkk, Tocchi, |
|||
| Top | |
|||
| Interceptor |
|
||
|
try it without a rebuild.....
_________________ Banned |
||
| Top | |
||
| Felony |
|
|||
|
yeah i might do that, and see how it goes, might have to do some surgery with hoses and wires as a lot has been frigged around by whoever dropped the clevo in...
Cheers
_________________ Succesful trades with bentles_eb, Pane, chunkz, xr8_dismantler, OBS35N, mrnasty, Steady ED, voxace, Mash85, ovo616, ef biff, lukey, dazza2924, Seannyb, gunit18, jkk, Tocchi, |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 66 guests |
