|
| roym |
|
||
|
how can I stop the water level dash light flashing ? even if I disconnect the float sensor it still flashes I have checked the sensor with an ohm meter it gives a 1.8 meg when level is O.K.
|
||
| Top | |
||
| alfy12 |
|
|||
|
If it's an EF coolant level warning system, anything over 2.5K ohm will cause it to flash. This is what the factory manual says:
Less than 70 ohm- Flash at 1Hz Closed switch 180 ohm- Light Off Open switch 1380 ohm- Light On More than 2.5K ohm- Flash at 1Hz If you fitted a resistor in the 150-200 ohm range across the contacts, it should stop the thing flashing provided we are talking EF system.
_________________ NF Fairlane: Non Factory Dual Fuel - New coolant tank, New fuel injectors, New fuel pump, New earth cable, ECU capacitors replaced, New O2 sensor, leads and plugs, New Radiator/Condensor cleaned. 483,000kms. AU I6 Powered. Struts, Shockies, Tie rods and ball joints replaced. |
|||
| Top | |
|||
| roym |
|
||
|
O.K. many thanks regards Roy
|
||
| Top | |
||
| MAD |
|
|||
|
Or you could take the globe out.
|
|||
| Top | |
|||
| fordman351 |
|
|||
|
Or you could fill the coolant tank
|
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 112 guests |
