|
aristopwr |
|
||
|
Ok, I must be doing something wrong but I have tried and tried without success..
I removed all my power window regs and glass to try and replace my bailey channels on my ED with EF/EL bailey channels..After seeing that the front glass was a tight fit (due to the EF/EL channels) I simply sourced the best EB/ED rubbers I could find..Now, I easily re assembled the front doors without a problem..My issue is with the rear windows..I am trying to figure out the procedure for installation is as I have tried insatlling the glass first then rubber but the glass won't go into the rubber..I have tried installing the rubber first but glass won't fit into the rubber.. I am hoping somone can tell me the proper way to to this..Thanks in advance.. |
||
Top | |
BenJ |
|
||
|
Hmmmm. From memory, I recall I installed the rubbers first, then undid the bottom bolts of the bailey runners so they could move. Then I slid the glass down into the door, but rotated so one corner went in first, and then once in the door turned to the correct orientation. Then I attached the window to the winder mechanism, wound the window up, and then bolted the bailey runners back into place.
Hope that helps. BenJ
_________________ BenJ's EB T5 DOHC Ghia Wagon - Current Ride |
||
Top | |
aristopwr |
|
||
|
Thanks mate.. I will give that a shot.. I remember when I tried to insert the glass with the rubber in place I could only get one side of the glass into the rubber, even when turned on it's side..The glass being curved doesn't help..Thanks again,
|
||
Top | |
BenJ |
|
||
|
Also make sure you have removed the outer weather strip that runs along the outside of the door.
Gives more room. BenJ
_________________ BenJ's EB T5 DOHC Ghia Wagon - Current Ride |
||
Top | |
GASSA |
|
||
|
Mate
I think the door glass is different on ed to el thickness size gassa
_________________ When the clutch drops the bull s**t stops!!!!! |
||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 30 guests |