|
| shazza9275 |
|
||
|
with my ef fairmont when the on button is pushed the cruise controll is stated on my dash but when i push accel set it doesnt lock my speed or anything like it use to
any ideas ? |
||
| Top | |
||
| stanbu |
|
|||
|
Check to see if your brake lights are working. Also the switch and plug going into the side of the brake master cylinder.
Stan |
|||
| Top | |
|||
| ef2xr6 |
|
||
|
i have the exact same problem, still not sure what is wrong with mine
|
||
| Top | |
||
| alfy12 |
|
|||
|
Check the switch on the side of the master cylinder is less than 1 ohm with a multimeter. Disconnect the CC servo plug (engine bay next to brake master cylinder)and put the multimeter between pins 5 and 6. Push the set+ (accel set) button and you should have 646 to 714 ohms resistance.
As mentioned, make sure brake lights function and your horn works (horn supplies 12V to switches).
_________________ NF Fairlane: Non Factory Dual Fuel - New coolant tank, New fuel injectors, New fuel pump, New earth cable, ECU capacitors replaced, New O2 sensor, leads and plugs, New Radiator/Condensor cleaned. 483,000kms. AU I6 Powered. Struts, Shockies, Tie rods and ball joints replaced. |
|||
| Top | |
|||
| shazza9275 |
|
||
|
it mesured 676ohms break lights work and so does horn
|
||
| Top | |
||
| alfy12 |
|
|||
|
What about the switch on the side of the master cylinder? If you have 12V on pin 9 of the cc servo plug, that switch is ok (ign on).
_________________ NF Fairlane: Non Factory Dual Fuel - New coolant tank, New fuel injectors, New fuel pump, New earth cable, ECU capacitors replaced, New O2 sensor, leads and plugs, New Radiator/Condensor cleaned. 483,000kms. AU I6 Powered. Struts, Shockies, Tie rods and ball joints replaced. |
|||
| Top | |
|||
| shazza9275 |
|
||
|
i got 13.38v across pin 9
|
||
| Top | |
||
| alfy12 |
|
|||
|
Quote: i got 13.38v across pin 9i got 13.38v across pin 9 Sounds spot on.When you got the 676 ohms pushing the set+ switch, did you rotate the wheel from lock to lock? I'd say your cruise control servo unit is stuffed. Just about everything else has been checked. The one thing that is hard to check is the input from the vehicle speed sensor. If your speedo is working and the car running normally, I would say it is ok. The only other thing you can try is a resistance check from pin 6 to pin 10. Should be greater than 1 ohm. If that checks out, time for another cc servo from the wreckers.
_________________ NF Fairlane: Non Factory Dual Fuel - New coolant tank, New fuel injectors, New fuel pump, New earth cable, ECU capacitors replaced, New O2 sensor, leads and plugs, New Radiator/Condensor cleaned. 483,000kms. AU I6 Powered. Struts, Shockies, Tie rods and ball joints replaced. |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 34 guests |
