|
FORD EL |
|
||
|
hey all im putting 245 35 19 on my el will hub adapters should i have any probs and i got it super lows all round
_________________ EL4LTR |
||
Top | |
cp1pgo |
|
|||
|
{USERNAME} wrote: hey all im putting 245 35 19 on my el will hub adapters should i have any probs and i got it super lows all round yes you will have a problem. the inside edge of the tyres will scrubb like mad so youl be tearing through tyres. you will have an even bigger problem using hub adaptors. they arent safe one bit lol. i recomend finding some pre au 19" rims. theres plenty out there. if you are really keen on getn 19"s all round only go to low springs not super low and also make sure the allingment is spot on or you will have the same problem of wearing the tyres out really quickly.
_________________ 1995 EF Ford Falcon Fairmont |
|||
Top | |
XRfairmont67 |
|
|||
|
he already has them on the car ,that post was 2 months ago, no problems besides a defect
|
|||
Top | |
cp1pgo |
|
|||
|
ah lol
i was just going through un answered posts and saw this one so i replyed. so he had no scrubbing problems what so ever?
_________________ 1995 EF Ford Falcon Fairmont |
|||
Top | |
XRfairmont67 |
|
|||
|
nah, room everywhere. makes me want 19s on my el now
|
|||
Top | |
cp1pgo |
|
|||
|
itd look sick
if i could find some decent ones with a pre au offset i would probably get em
_________________ 1995 EF Ford Falcon Fairmont |
|||
Top | |
fordfreak ef |
|
|||
|
even 235/245/30/20's fit with a bit of guard rolling..lol
|
|||
Top | |
ply-boi |
|
|||
|
few taps with a hammer wont hurt anything
|
|||
Top | |
fordfreak ef |
|
|||
|
{USERNAME} wrote: few taps with a hammer wont hurt anything has to be rubber... or else you will crack and chip paint.... hehe... |
|||
Top | |
ply-boi |
|
|||
|
not if its on the inside, front , or rear of the arch
|
|||
Top | |
WGN-485 |
|
|||
|
if your gonna roll em yourself be so careful if using a hammer like others said the paint can crack and you can also end up with some dints on the outside of the guard.
The guard metal isnt thick at all......good luck otherwise some panel beaters ect will take your arm for the fronts and a leg for the rears.
_________________ EF Turbo Track Hack Last edited by WGN-485 on Wed Oct 28, 2009 11:30 pm, edited 1 time in total. |
|||
Top | |
the sam |
|
||
|
i got 235/35/20s on superlows at the rear, lows at the front and im fine. had a little trouble with the front upper ball joint mount, but got it sorted.
_________________ LOW, LOUD AND LUMPY |
||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 54 guests |