advice for better fuel system for new mod's to 302w
at moment running old holly 650 vac on 289 Torker,standard fuel pump, walker headers

NEW MOD'S
crack tested & Balanced
Honed 40k
ACL pistons & bearings
289 grind cam
Yellar terra bolt on rockers
ford windsor v8 heads. Heads fully reco/strip and bead blast/ crack and
> pressure test/ surface v8 heads/ full port job to suit cam specs/ 3 angle
> seat cut and face valves/ springs tested(110 ft/lbs seat pressure)/ fit
> new valve stem seals/ new cam and lifters. cam specs-valve lift inlet .474
> exh .498. inlet 30/78; ex81/39,

any advice would be welcomed
almost run in
Cheer's Devondevil

On the 650, put a pair of centre float bowls on, a splitter for the fuel lines, electric pump ( using oil pressure switch to turn it on )....try 64's in the front. Also, fit the 350 Holley accelerater nozzle, they give better direction.
Fit MSD or ICE ignition system and regraph the dizzy.
You didn't say if it was an auto or not.
Did you dial in the cam???

Thx cjh
for your reply & advice,
yes cam was dialed in,
we have taken our time so no mistakes,
drove it the other day it has a very bad dead spot at pick up, to pass that you have to put the foot down & wait-but gotta make sure nothing is in front off you tho,the carby is still has was taken off engine before the rebuild & mods, going for tune next week we'r not to sure if to stay with that carb or look around for another system,
it is auto with new thundermax ignition system,there's no spark problem for sure
we are new to this & that's why this site & you guy's are a god-send
PS can a 7.55mb 22 sec video clip be uploaded on here?
again thanks
devondevil

Sort of...the film clip.....post it to youtube, then post the link to youtube.
You didn't say if you regraphed the dizzy.
Where did you set the cam too...retarded...dot to dot...advanced?????
What diff gears are you running???
What comp ratio are you running???
What car are you running it in???.....XR, XT, XW...something else....Capri, Escort????
What size power valve are you running????
I have found the spreadbore carby's to be good alround ones, good low down torque and economy when you want it.

Sorry cjh
It's my son's XF ute "pic below" its a project we have been working on,all tech work was done by professional, will get back to you about your questions asap
cheer's devondevil

 

 

Attachments:

11-10-09_1102.jpg [ 37.89 KiB | Viewed 196 times ]

Nice ute.....have ya put rear disc brakes on it????

Hi cjh
it has disc's all round,
we are going to do what you advised with Holley then put her in for dyno tune.

cheer's
devondevil