|
jordancoe |
|
||
|
hi i want to lower my ed but am on my ps so i dnt want to make to too low so i get in s**t with cops. i was thinking about just king springs lowed(not super low or ultra low) but was told that u have to put superlows on the back to even the car out does anybody now if this is tru. and how much would it cost me for the 4 springs
|
||
Top | |
jvangent |
|
||
|
not too sure about the ED's. on my EF i put superlows all round. looks good to me.
|
||
Top | |
TROYMAN |
|
||
|
i dont think you need superlows in the rear...
i got lows all round and the rear sits lower than the front... |
||
Top | |
itlookslikeaxr6 |
|
|||
|
Take it to a suspension place tell them you want it lowered but to sit flat and get a qoute. I did that but fit it myself after they ordered it. So i dunno what springs i have but its lowered and sits flat lol
_________________
|
|||
Top | |
Campbell18 |
|
|||
|
after changing my rims from stock to 18's, I noticed that the rear of the car was significantly higher then the front
i managed to score a set of 4 lovells superlows for about $150 even with these in the rear, the car still sat a touch to high in the end i decided to chop a coil off each ( i know its not the recommended thing to do), now the car sits about 2 cm above the legal limit as far as the police go, you shouldnt have any problems aslong as your car sits above the 10cm mark. hope this helps
_________________ ED 4.0L auto... pacemaker PH4480, Aus Pac Catback exhaust, wade 1636 with j3 tune =130rwkw |
|||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 42 guests |