|
| Bassy500 |
|
||
|
I was wondering if someone could give me some insight into lowering a ba xr6 turbo.
i wondering if its possible to lower them couple of inches (not looking for speed hump scraper) with a set of new springs and not buying new shocks and camber kit? Or this is strongly recommended against? |
||
| Top | |
||
| madeaspack |
|
||
|
i got a set of lovells ssl's (not yet installed) they claim 40-60mm lower,but i think after 30mm lower the bumpstops touch
_________________ 97 el xr6,5 speed short shifter,sequential scoop,no arial,freshly resprayed,low on 17's,3 inch zorst,stainless hi flo cat,snort stage 3 stainless manifold,garrett t04e,front mount cooler,wolf 3d ecu,seimens 760cc injectors,walbro fuel pump |
||
| Top | |
||
| lil_lincoln |
|
|||
|
mine sat on kings super lows all round. it looked good but i would never go any lower as it scraped a bit and once almost pulled the bar off. ssl you wont get over a speed hump from xr height i think.
_________________ |
|||
| Top | |
|||
| lil_lincoln |
|
|||||
|
it sat like this
_________________ |
|||||
| Top | |
|||||
| DoddEA |
|
||
|
lil_lincoln wrote: mine sat on kings super lows all round. it looked good but i would never go any lower as it scraped a bit and once almost pulled the bar off. ssl you wont get over a speed hump from xr height i think. I have SSL in the rear, and SL in the front. No real issues.. but then i dont have the XR Kit to worry about. |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 49 guests |
