|
| ford-racer46 |
|
|||
|
Hi there ford modders, Can i put an AU head on any EA-EL bottom end?
_________________ Now, I've got a message for all the other drivers out there. If you smell a delicious, crispy smell after the race, it's not your tailpipe. It's just a little of Shake...and Bake! |
|||
| Top | |
|||
| TROYMAN |
|
||
|
yes... it is a direct swap... but if you use au head you should use au cam and rockers..
|
||
| Top | |
||
| ford-racer46 |
|
|||
|
Your an absolute legend man thankyou for your reply i was worried because i have an AU1645 and didnt wanna wast it on an eb bottom
_________________ Now, I've got a message for all the other drivers out there. If you smell a delicious, crispy smell after the race, it's not your tailpipe. It's just a little of Shake...and Bake! |
|||
| Top | |
|||
| xcabbi |
|
||
|
TROYMAN wrote: yes... it is a direct swap... but if you use au head you should use au cam and rockers.. Should or must? I thought the cam and rockers were interchangeable provided that you use the same model cam and rockers. i.e. EF cam and rockers can go onto an AU head but you can't fit an EF cam to AU rockers, or vice versa. Is this correct or way off? |
||
| Top | |
||
| cjh |
|
|||
|
I thought someone had tried that, AU head with EF cam & rockers but the rockers don't line up with the valves and the cam doesn't fit properly because of the thrust face?????????
Someone correct me..... 
_________________ http://youtu.be/jJTh9F3Vgg0 |
|||
| Top | |
|||
| TROYMAN |
|
||
|
i have fitted an au cam and rockers to an ef head turned it over by hand but never ran the engine..
the only thing i would be concerned about is if the valve lengths were different.. |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 93 guests |
