|
| i6_demon |
|
|||
|
Hi guys been cruising fordmods for a couple of months now but first time poster . . . I have an eb I monty and I cannot get the a/c fan to turn off even after I turn the car off. . . I can't seem to find a fuse for it to disconect it and I have tried changing the control box with an old one out of my ea monty . . . So I disconected the plug directly from the fan under the dash as I can't seem to figure out what the problem is and I was left wondering if it has something to do with the ignition?? Any advice is greatly appreciated and if u guys do think it is the ignition would th ignition from my ea monty go straight in without any ecu issues because of smartlock or not?
|
|||
| Top | |
|||
| i6_demon |
|
|||
|
Oh and by the way sorry if I have posted this in the wrong forum . . . Didn't quite know if this was the right place or not but coz its a 3.9 I thought this would be the best place to start . . . Lol
|
|||
| Top | |
|||
| i6_demon |
|
|||
|
Anyone???? Even a hint in the right direction would be greatly appreciated . . .
|
|||
| Top | |
|||
| philaddis |
|
|||
|
sounds like a dodgy fan speed controller to me.
Try doing a diagnostic reset on the climate control and check for any faults. If none, then you'll have to start fault finding.
_________________ ED XR8 Spri-mitatio-nt |
|||
| Top | |
|||
| i6_demon |
|
|||
|
Thanks for the reply mate - much appreciated - will try what you have suggested and well see how we go ey . . . Cheers
|
|||
| Top | |
|||
| chr!s |
|
||
|
i have the same prob, how did u go?
Also, how do you do the diagnostic reset thingo? |
||
| Top | |
||
| thatrandykid |
|
||
Age: 33 Posts: 83 Joined: 13th Dec 2009 Ride: au II ute, 63' xl falcon ute Location: geelong |
Put the ignition to on (with motor not running) and press floor and the off button at the same time.. takes around 20-30 secs to reset.. I think that's how you do it but I may be wrong
_________________ au II ute, cam, mild porting/xr6 head, headers and zorst |
||
| Top | |
||
| chr!s |
|
||
|
well mine was doing similar problems so i replaced the fan speed controller and it is fixed. do this, i promise it will fix it and it only takes 15 minutes to do...
first, acquire a fan speed controller from a wrecker, mine cost $45- i know it was a rip but i was desperate... then pull out the glove box. then undo about four plugs. then remove four screws and manipulate it out. then clean out all of the leaves. then replace. plug in the plugs. put in the glovebox. done. |
||
| Top | |
||
| i6_demon |
|
|||
|
gday mate good to hear u found the solution hahaha thanks for the tip . . . at the moment i have just taken out the glovebox and im just plugging in and out the fan cable or wateva it is but its not worrying me too much - especially since the fan control costs that much!!! besides my eb is a heap of s**t - just used to get from a-b until i fix my new car . . . if i can find one cheap enough i might do it XD cheers buddy
|
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 38 guests |
