|
| TROYMAN |
|
||
|
if it was an lpg tune he would have used a seperate o2 sensor up the exhaust not the factory one...
if its not running right take it back and tell the guy that tuned it its no good... |
||
| Top | |
||
| -GAS-MAN- |
|
|||
|
Ive noted a few places to start below:
[html]http://www.fordmods.com/viewtopic.php?f=1&t=86747[/html]
_________________ it can be fast and cheap,but it wont be reliable |
|||
| Top | |
|||
| ke55pig |
|
||
|
he used the factory 02 sensor i watched and also i taken it back and he said its nothing to do with the gas tune.That i should get the timing looked at and advanced if it not that he doesnt no and i should take it to ford
|
||
| Top | |
||
| 67RCE |
|
||
|
ke55pig wrote: he used the factory 02 sensor i watched and also i taken it back and he said its nothing to do with the gas tune.That i should get the timing looked at and advanced if it not that he doesnt no and i should take it to ford how did it get tuned using a narrowband sensor? Timing won't be out too far if at all, or otherwise it would have pinging, or not run. Get a decent gas tune done.
_________________ ILL60 - EF XR8, Sunroof, Ticky Kit, 19x8.5/19x11 TE37's, 347, AFr185's, TFS BoxRcustom converter, Hurst Quarterstick, huge billet cam. |
||
| Top | |
||
| ke55pig |
|
||
|
i dont no he stuck his multimeter thing in and read it and yea mesed around with it and toldme it was perfect
|
||
| Top | |
||
| ebxr82nv |
|
||
|
sounds like he doesnt know s**t from clay
_________________ 9/98 AU1 XR6hp-about to retire from the road and be reborn on the race track. |
||
| Top | |
||
| Sturmovik |
|
|||
|
Yeah he should have been using a wideband sensor.
Take it somewhere else Quote: Narrowband oxygen sensors are extremely inprecise. They can't tell the computer the exact air/fuel ratio like wideband oxygen sensors. Technically narrowband oxygen sensors produce an exponential voltage signal, whereas wideband oxygen sensors produce a linear current signal. When the air/fuel ratio is perfectly balanced, a narrowband O2 sensor produces a signal of about 0.5 volts (500 millivolts). When the fuel mixture goes rich, even just a little bit, the O2 sensor's voltage output shoots up quickly to its maximum output of close to 0.9 volts. Conversely, when the fuel mixture goes lean, the sensor's output voltage drops to 0.1 volts.
_________________ 1993 ED XR6 5speed Polynesian Green. Project car. |
|||
| Top | |
|||
| fal98con |
|
|||
|
Check your mixer, mine was leaking, tightened one bolt performance back and much better economy.
_________________ R.I.P My red beast |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 68 guests |
