|
| alfy12 |
|
|||
|
Having some dramas with the airbag in the fairlane. Initially had a code 12 so found the airbag fuse was blown. Replaced it and then got code 52. Tried the reset procedure by shorting the airbag pin to ground after the airbag light stops flashing the code. It is surpose to sound 5 beeps but I get nothing when attempting the reset. Car is due for pink slip soon so need to get it sorted. Any suggestions appreciated.
_________________ NF Fairlane: Non Factory Dual Fuel - New coolant tank, New fuel injectors, New fuel pump, New earth cable, ECU capacitors replaced, New O2 sensor, leads and plugs, New Radiator/Condensor cleaned. 483,000kms. AU I6 Powered. Struts, Shockies, Tie rods and ball joints replaced. |
|||
| Top | |
|||
| SV-Valiant |
|
||
|
Quote: Car is due for pink slip soon so need to get it sorted. Any suggestions appreciated. Yep pull the bulb out of the cluster then they wont know if you cant fix it before hand Cheers Alan |
||
| Top | |
||
| Sloxr6 |
|
|||
Age: 40 Posts: 862 Joined: 8th May 2005 Ride: BA Wagon Turbo, Ba Fairlane G220 Location: Colac |
SV-Valiant wrote: Quote: Car is due for pink slip soon so need to get it sorted. Any suggestions appreciated. Yep pull the bulb out of the cluster then they wont know if you cant fix it before hand Cheers Alan Cant just pull it out. It beeps with no bulb or a blown one.
_________________ Congo Green Ba Wagon With F6 6 Speed Manual Driveline. |
|||
| Top | |
|||
| SV-Valiant |
|
||
|
Sloxr6 wrote: SV-Valiant wrote: Quote: Car is due for pink slip soon so need to get it sorted. Any suggestions appreciated. Yep pull the bulb out of the cluster then they wont know if you cant fix it before hand Cheers Alan Cant just pull it out. It beeps with no bulb or a blown one. Mine didnt beep when i pulled mine out for its road worthy certificate? |
||
| Top | |
||
| Sloxr6 |
|
|||
Age: 40 Posts: 862 Joined: 8th May 2005 Ride: BA Wagon Turbo, Ba Fairlane G220 Location: Colac |
Bloody mine did wish it didn't would be an easy fix
_________________ Congo Green Ba Wagon With F6 6 Speed Manual Driveline. |
|||
| Top | |
|||
| SV-Valiant |
|
||
|
Alfy if its not beeping now pull the bulb out if you cant fix before the safety certificate.
|
||
| Top | |
||
| Sloxr6 |
|
|||
Age: 40 Posts: 862 Joined: 8th May 2005 Ride: BA Wagon Turbo, Ba Fairlane G220 Location: Colac |
SV-Valiant wrote: Alfy if its not beeping now pull the bulb out if you cant fix before the safety certificate. I got a wagon going in tomorrow might try that didn't even try. Might have something to do with higher spec models cause i pulled it out of my XR6
_________________ Congo Green Ba Wagon With F6 6 Speed Manual Driveline. |
|||
| Top | |
|||
| alfy12 |
|
|||
|
Sounds like pulling the bulb might be the answer. I will substitute a resistor the same value as the bulb so the diagnostic monitor can't tell the difference. Thought someone might know of a fix but the bulb removal will do in a pinch.
Thanks everyone for the suggestions.
_________________ NF Fairlane: Non Factory Dual Fuel - New coolant tank, New fuel injectors, New fuel pump, New earth cable, ECU capacitors replaced, New O2 sensor, leads and plugs, New Radiator/Condensor cleaned. 483,000kms. AU I6 Powered. Struts, Shockies, Tie rods and ball joints replaced. |
|||
| Top | |
|||
| Sloxr6 |
|
|||
Age: 40 Posts: 862 Joined: 8th May 2005 Ride: BA Wagon Turbo, Ba Fairlane G220 Location: Colac |
Maybe you should try the reset again I did it today and it worked a treat it took a few goes but I finally got it I ended up earthing the pin just after I turned the ignition on.
_________________ Congo Green Ba Wagon With F6 6 Speed Manual Driveline. |
|||
| Top | |
|||
| alfy12 |
|
|||
|
Thanks sloxr6. I'll try it again at lunch time. Did your car beep 5 times like the factory manual says?
_________________ NF Fairlane: Non Factory Dual Fuel - New coolant tank, New fuel injectors, New fuel pump, New earth cable, ECU capacitors replaced, New O2 sensor, leads and plugs, New Radiator/Condensor cleaned. 483,000kms. AU I6 Powered. Struts, Shockies, Tie rods and ball joints replaced. |
|||
| Top | |
|||
| Sloxr6 |
|
|||
Age: 40 Posts: 862 Joined: 8th May 2005 Ride: BA Wagon Turbo, Ba Fairlane G220 Location: Colac |
Yeah took me a few goes I was about to give up like you. Maybe use a bigger bit of wire I was using a skinny bit for awhile changed to a bigger one and it worked straight away not sure where it was a coincidence or not but I was just happy it worked
_________________ Congo Green Ba Wagon With F6 6 Speed Manual Driveline. |
|||
| Top | |
|||
| alfy12 |
|
|||
|
Pulled the light bulb out yesterday after trying the reset a few more times. No beeping and no light.
_________________ NF Fairlane: Non Factory Dual Fuel - New coolant tank, New fuel injectors, New fuel pump, New earth cable, ECU capacitors replaced, New O2 sensor, leads and plugs, New Radiator/Condensor cleaned. 483,000kms. AU I6 Powered. Struts, Shockies, Tie rods and ball joints replaced. |
|||
| Top | |
|||
| Sloxr6 |
|
|||
Age: 40 Posts: 862 Joined: 8th May 2005 Ride: BA Wagon Turbo, Ba Fairlane G220 Location: Colac |
Oh well at least it is all sorted good luck with your roady
_________________ Congo Green Ba Wagon With F6 6 Speed Manual Driveline. |
|||
| Top | |
|||
| SV-Valiant |
|
||
|
See it was easier to pull the bulb out and no beeping, after the road worthy i replaced my bulb and then Mine stopped after i replaced the front i suppose its the sensor for collision inpact its under the front skirt cover as you open your bonnet. give that ago if you have another one around and see what happens.
Alan |
||
| Top | |
||
| alfy12 |
|
|||
|
Thanks Alan. I think mine is somehow power related as it failed after I stupidly connected some wiring in reverse. I think the only way to fix it is to replace the airbad diagnostic monitor circuit behind the instrument cluster. Will hopefully get around to fixing it down the track.
Cheers
_________________ NF Fairlane: Non Factory Dual Fuel - New coolant tank, New fuel injectors, New fuel pump, New earth cable, ECU capacitors replaced, New O2 sensor, leads and plugs, New Radiator/Condensor cleaned. 483,000kms. AU I6 Powered. Struts, Shockies, Tie rods and ball joints replaced. |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 118 guests |
