|
| tjb45 |
|
|||
|
This might sound like a stupid question, but is there anyway to get rid of the MAF sensor on a multipoint XF and keep the factory ecu? My understanding is it just puts out an electrical signal to the ECU, so would it be possible to connect a MAP sensor from and EF or something and wire that to the standard ecu??
Thanks. Tim |
|||
| Top | |
|||
| raiki |
|
|||
|
Simple answer, No !!!!!!!
_________________ Adrian
|
|||
| Top | |
|||
| justfordima |
|
|||
|
to extend what was just said, the MAP sensors work on a frequency, and not really a varialbe voltage like the MAFs, you'll need to look at something else.
Cheers
_________________ ;++JustForDimSim++;
|
|||
| Top | |
|||
| Spork |
|
|||
|
No!
MAP and MAF sensors work entirely differently. Without using too many words: You can have 0 vaccum at wide open throttle anywhere in the rev range =same sensor output. A MAF measures the mass of air so it will change depending on RPM and MAP.
_________________ Manual EL Gli.
|
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 29 guests |
