|
| FORDom |
|
||
|
Hey guys, i think thats what its called, anyway ive had coolant dropping on it and apparently thats whats causing my car to not run right at all (not drivable)
 those two photos' show that part im talking about. Anyway is it just a case of removing the cable connection and the two bolts on the top and swapping it with the new part or do i have to have the motor in a certain position.? also would coolant getting inside it and corroding the terminal cause the car to have electronic misfires, extremely rough idle and blowing smoke out of the exhaust? |
||
| Top | |
||
| krisisdog |
|
|||
|
So who told you thats whats making your car run poorly?
|
|||
| Top | |
|||
| FORDom |
|
||
|
those photo's arent of mine..mines fully contaminated with cooland and coroded the wiring..so can a faulty cam angle sensor cause my symptoms? and is it at easy as removing the old on and replacing it straight back in?
|
||
| Top | |
||
| SWC |
|
||
|
When you get a new one, swap the gear from your old one to the new one. Gear will then match the auxillary gear. Fitting the new one is much like fitting a new dizzy.
|
||
| Top | |
||
| FORDom |
|
||
|
ok ill see how i go, hopefully i don't have to remove the inlet manifold to do the job.
|
||
| Top | |
||
| SWC |
|
||
|
If I can get the bloody dizzy out of the EL Wagon you will have no trouble with the cam sensor.
|
||
| Top | |
||
| alfy12 |
|
||||||
|
These little gems might help. If the plug is corroded, get another from a donor car and solder the wires. Heatshrink each wire and them wrap the whole wiring loom in tape. For the locating pin I used a 4mm drill bit which was shortened to miss the front of the engine (any 4mm dowl will do. Just remember to remove it when finished).
_________________ NF Fairlane: Non Factory Dual Fuel - New coolant tank, New fuel injectors, New fuel pump, New earth cable, ECU capacitors replaced, New O2 sensor, leads and plugs, New Radiator/Condensor cleaned. 483,000kms. AU I6 Powered. Struts, Shockies, Tie rods and ball joints replaced. |
||||||
| Top | |
||||||
| FORDom |
|
||
|
well i just installed just the top of the cas (the plastic part that bolts on) and replaced the plug and wiring (wasn't even coroded) and now she wont run at all? Will try some more things on thursday night, f**k
|
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 58 guests |
