|
| excopau |
|
||
|
Has anyone upgrade there brakes on there au series 1 to series 2 or other conversions from other places and how much did it cost and where to get it from for the best deal?
_________________ JUST LOVE BLOWING THE DOORS OFF HOLDEN PIECES OF S--T! |
||
| Top | |
||
| Disco Frank |
|
|||
|
yes someone has made the au1 to au2 upgrade
it quite easy u need au 2 calipers( or get some vt calipers they are the same )/rotors the au 2 uprights and stub axles also need teh au 2 sway bar i think you have to drill 1 or 2 holes for the au2 sway bar to mount it
_________________ RIP SCOTT |
|||
| Top | |
|||
| fuzion |
|
||
|
supposedly u dont use au swaybars tho?
ring (02) 9600-6229 and ask for Joe and say fordmods sent u and he'll tell u / or get it done there? |
||
| Top | |
||
| XITED6 |
|
||
|
call hightek brakes 95331160 located in melbourne supplies all your brake pads discs etc etc also posts interstate
_________________ AU II XR6 Hp 5 Speed. |
||
| Top | |
||
| LG |
|
|||
|
You'll also need to upgrade to 16s or higher, and need new suspension parts. So i've heard, but best speak to an expert. Theres a place in Melbourne, where you can get a full pbr performance package for $1785, not sure whether that's fitted or not.
_________________
|
|||
| Top | |
|||
| xr8 dismantler |
|
|||
|
you need to change the lower control arms also to fit these brakes.
we can supply the kit from a BA or a AU to fit au series 1 but there not cheap. best to go for the BA as they have slightly larger rotors prices are as follows lower control arms $300 each ouch!!! stub axles $175 each rotors $45 each calipers $75 each sway bar & fittings $100 total $1290 and if you say your from fordmods when you order i throw $50 fordmods way |
|||
| Top | |
|||
| 99 tonner |
|
|||
|
I can get it done for around $800 here in Sydney drive in drive out.
_________________ T402 ISX 500hp daily driver |
|||
| Top | |
|||
| ghiaman |
|
|||
|
xr8 dismantler wrote: you need to change the lower control arms also to fit these brakes.
we can supply the kit from a BA or a AU to fit au series 1 but there not cheap. best to go for the BA as they have slightly larger rotors prices are as follows lower control arms $300 each ouch!!! stub axles $175 each rotors $45 each calipers $75 each sway bar & fittings $100 total $1290 and if you say your from fordmods when you order i throw $50 fordmods way I would of thought that only the steering knuckle ( stub axle ). Hub assembly, rotor & caliper for the swap over. Does the AU2 on have a different offset on the lower control arm or different lwr ball joint. ghiaman |
|||
| Top | |
|||
| Disco Frank |
|
|||
|
and the sway bar is different as well cant use au1 swaybar on au 2 setup
muts have different lower ball joint?
_________________ RIP SCOTT |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 156 guests |
