Ok, brag first.
Today I picked up a PBR rpm Performance clutch (new) for $130.
With that I got a list of goodies for free I guess.
Max Ellerys repair manual, like new.
AC belt, pump belt and some other belt. New
1 brake hose, PBR
2 fuel filters. 1 Valvoline 1 cheap.
Transmission mount, new.
2 rear wheel bearings.
Water pump neck, new.
2 stud with bushes, from ford.
2 repco universal joints? What are these. Look like a +.
A few other bearings.
2 new ball joints.
Not bad for $130.

Now the questions.
When I replace the studs with the new ones and bushes how tight do I tighten them up?

Well that's my only real question now that I have the manual.

Cheers.

Torque settings will be in the repair manual

The manual has everything to do with replacing the front assemblies and all the NMs except the one I need.
Maybe you just tighten them up till the look like the pics.?

Ok so I installed the new studs and bushes today. The old ones were F**k. There was rocks burried in them?
anyway drives a bit nicer now.
Couldn't find the fuel filter, I found something like a fuel filter towards the rear. It had nuts to take the lines off tho. Do ebs have screw on fuel filters.

yes.
its all in the repair manual.

eb-au have the fuel filter at the pasenger rear of the car and have nuts that fasten the lines to the filter..
where ea had the filter just below the firewall on the passenger side and have push on hosses with clamps...

My cars a eb1 and its at the back?
So I need a screw on one.
The manual says the fuel filter is easily replaced apon inspection.
Stupid manual.