|
| 87SIlude |
|
||
|
Hey everyone.
Just wondering if I was to remove my inlet maniford and clean inside it and the throttlebody would there be a noticable difference? |
||
| Top | |
||
| SV-Valiant |
|
||
|
Nope
|
||
| Top | |
||
| LTDHO |
|
|||
|
Nope.
Cleaning sensors and injectors will though. |
|||
| Top | |
|||
| 87SIlude |
|
||
|
Yea I was going to do that aswell at the same time. Just wondering if I was gonna be wasting time.
Wich and how do I clean the sencors. And car I clean the injectors myself? |
||
| Top | |
||
| Johnson stroker |
|
|||
|
better off removing the injectors and getting them sonic cleaned, Sensors to clean? Stuff like TPS, ISC (not really a sensor but can't hurt) bits and pieces like that.
You could always get your manifold extrution honed, again no gain unless big power and BIG air flow is called for. BTW, your log manifold makes a good plenum in turbo apps too.
_________________
|
|||
| Top | |
|||
| 87SIlude |
|
||
|
Yea ill do that then, ICS is clean thought there might have been some others.
Log manifold ftw. Can actually change my leads without taking half the engine off. |
||
| Top | |
||
| Johnson stroker |
|
|||
|
So can I,
87SIlude wrote: Can actually change my leads without taking half the engine off. So can I, it just gets done from underneath with a proctologists approach.
_________________
|
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 80 guests |
