|
luckie |
|
||
|
Can anyone help with a weirdo fault with my ECM?
When I turn the key on the fuel pump runs continuously. The engine will not start. If I spray fuel into the TB she starts and dies after 2 seconds. This is a 1991 EB Mont 5.0 pre smartlock Power to the injectors is 12v ECM power is all good Just no injector fire This is a ECM FUBAR isn't it?? |
||
Top | |
67RCE |
|
||
|
Could be a TFI issue, if the TFI doesn't work, it will cut the ECU pulse to the injectors
_________________ ILL60 - EF XR8, Sunroof, Ticky Kit, 19x8.5/19x11 TE37's, 347, AFr185's, TFS BoxRcustom converter, Hurst Quarterstick, huge billet cam. |
||
Top | |
xafalcon |
|
||
|
These are the same symptoms that my ecu had. I also couldn't get codes from it either, absoluetly no code output at all. It was a 1DHA. My car was dual fuel with the injector 12 volt feed shut off for LPG operation. The car was running OK on LPG and I checked the fuel usage on the trip computer (would normally get figures like 10L/100km as the ecu didn't know the pulses being sent to the injectors were doing nothing). It read zero litres per 100km's. Switched to petrol, and no go. Tried to read codes, nothing. New ecu and all was good.
_________________ XA Faimont 351C, AU2 XR8 Manual 5.0, DA LTD 5.0, Mk1 Capri 5.0, 1995 Mustang 5.0, EF2 XR8 Manual, EF2 Fairmont Ghia 5.0, AU3 XR8 Auto, AU2 XR8 Auto, AU2 XR8 Manual Ute, TE Cortina 5.0 Manual, DU LTD 5.0 soon to be manual |
||
Top | |
luckie |
|
||
|
If the TFI was at fault would it not stop spark as well
I seem to have spark as when I spray fuel into TB she fires up for a moment |
||
Top | |
XR9UTE |
|
||
|
The ROM is screwed...new EEC time.
|
||
Top | |
luckie |
|
||
|
Gives me an excuse to upgrade
Thanks for the info Cheers |
||
Top | |
j rod |
|
||
|
{USERNAME} wrote: Can anyone help with a weirdo fault with my ECM?
When I turn the key on the fuel pump runs continuously. The engine will not start. If I spray fuel into the TB she starts and dies after 2 seconds. This is a 1991 EB Mont 5.0 pre smartlock Power to the injectors is 12v ECM power is all good Just no injector fire This is a ECM FUBAR isn't it?? |
||
Top | |
j rod |
|
||
|
i would check dizy first as pick up coil inside probally at fault have had same fault on bronco same fault tfi modle did not work as load to ecm to much replace dizzy with same module .If this doesnt work check feeds to ecu and earth connections
|
||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 47 guests |