|
sdoylie |
|
||
|
looking at smoothing out my xh a bit. i want to get rid of the tarp strap clip holes, door locks and even thinkin about getting rid of the door moulds completly and fitting some flat sheet so that the panels are dead straight and smooth. my panel beater recons with the heat from the welder and the thiness of the metal there will be major distortion in the metal. im sure someone has done this already. did you have any dramas?
cheers. |
||
Top | |
OZBMX |
|
|||
|
it's doable, but it isn't easy, but most competent panel beaters should be able to handle it.
competent
_________________ Signature removed by moderator.signature must not exceed 120x500 pixles |
|||
Top | |
chuck |
|
|||
|
See if you can get onto a sheety about it, if he's any good he should be able to controll the heat, with the use of a pulse tig, or something similar, not sure it would be too cheap, unless you could organise slab payment have you checked to see if its actually legal to do that? I mean some buracrat may have a whinge about it, but I guess if you used the same thickness and metal it should be fine? I'm not to sure, but I'd look into it.
Charlie
_________________ {DESCRIPTION} |
|||
Top | |
XRfairmont67 |
|
|||
|
time to find another panel beater if he cant weld without distorting it too much
|
|||
Top | |
chuck |
|
|||
|
True that,
_________________ {DESCRIPTION} |
|||
Top | |
sdoylie |
|
||
|
fair call guys. cheers. i think ill just stick with welding up the tray bits and locks for now. might weld the tailgate shut too, for that extra smooth look.
|
||
Top | |
sdoylie |
|
||
|
just updating. me beater said he is going to silver solder the holes in. hardly any heat distortion and a better option than bog. haha.
|
||
Top | |
sooty72 |
|
|||
|
Won't the silver solder crack and break loose after a while? As above, a decent panel beater can mig weld the holes, so there gone for good, and will use minimum bog.
_________________ Yes, I own a Ute. No, I won't help you move! |
|||
Top | |
sdoylie |
|
||
|
haha. ashcook. its getting an almost bare metal respray, so ill guess we'll what we find. haha.
probably get him to strengthen the door hinges while he's at it. im going with his knowledge as a beater with the silver solder or brazing. hope it doesnt bite me in the a***. |
||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 25 guests |