|
WARMACHINE |
|
||
|
Alrighty
Ive just spent the last week installing the explorer manifold slowly and now im stuck. When i removed the dizzy i rotated the engine to #1 on the cap, installed manifold and all vac lines etc. Only thing not plugged up is the iat sensor as it seems to be beyond stuck in the h.o... Anyway i made sure i rotated the engine tp tdc on comp stroke, installed dizzy and it was out so i adjusted dizzy till it was on #1 (i marked it with a dot) and tightned the bolt. The problem I cant get it into base timing mode to set my timing, im just wondering if there is something ive done wrong when installing the dizzy as i tried to drive it (big no no) and the turbo was basicaly building boost instant the throttle is touched ie even for cruize. When i got it home (drove around the block) the headers were glowing red hot.. So i know its a timing issue.. but were did i go wrong???? |
||
Top | |
hans hartman |
|
||
|
{USERNAME} wrote: Alrighty Ive just spent the last week installing the explorer manifold slowly and now im stuck. When i removed the dizzy i rotated the engine to #1 on the cap, installed manifold and all vac lines etc. Only thing not plugged up is the iat sensor as it seems to be beyond stuck in the h.o... Anyway i made sure i rotated the engine tp tdc on comp stroke, installed dizzy and it was out so i adjusted dizzy till it was on #1 (i marked it with a dot) and tightned the bolt. The problem I cant get it into base timing mode to set my timing, im just wondering if there is something ive done wrong when installing the dizzy as i tried to drive it (big no no) and the turbo was basicaly building boost instant the throttle is touched ie even for cruize. When i got it home (drove around the block) the headers were glowing red hot.. So i know its a timing issue.. but were did i go wrong???? i had the same when i droped a new motor in,your 1 tooth out on the dizzy,i pulled mine out 9 times to get the advance.remmber its 30 deg btdc-not tdc,when i got it fired straight up and set timing
_________________ R.I.P HANS HARTMAN |
||
Top | |
WARMACHINE |
|
||
|
Ill give it another go over, when i got tdc on pis1 the balancer is on 0 deg is that right?
|
||
Top | |
Steady ED |
|
|||
|
you must still be out, either that or TDC on your balancer is wrong (if you didn't manually check).
why can't you go into diagnostic?
_________________ ED XR8 Sprint - S-Trim, V500, 249rwkw |
|||
Top | |
WARMACHINE |
|
||
|
I dont know it just wont...
tried it 5 times in a row to make sure i was doing it right... |
||
Top | |
hans hartman |
|
||
|
{USERNAME} wrote: I dont know it just wont... tried it 5 times in a row to make sure i was doing it right... you know the dizzy spins anti clock wise and tdc its fired or almost finished
_________________ R.I.P HANS HARTMAN |
||
Top | |
WARMACHINE |
|
||
|
Ok i ended up finding my problem, it was a bolt and washer i had placed infront of the throttle cable bracket causing it to rev @ 2000rpm.
I set the dizzy and did the timing set to 30* but i did it while engine was cold. Got it sorted and its home now, still needs tps etc set. Thanks hans. |
||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 32 guests |