|
| henry95ef |
|
|||
|
hey guys my ef falcon has been coughing and spluttering for a few weeks, some times completely stalling, i replaced the fuel filter and it went great for a day or so, i checked and wasn't getting any spark so i replaced the coil pack still no spark, i'm getting power to the coil pack but nothing after.....................
Need ideas guys as i've missed a days work already so far trying to figure this out
_________________ Skidz are cooooool!
|
|||
| Top | |
|||
| Shadow Keeper |
|
||
|
Maybe a fault with the cam angle sensor located where the distributor would normally be in a non coil pack engine.
|
||
| Top | |
||
| henry95ef |
|
|||
|
i cleaned the connection but it made no difference, it has a timing chain noise so was just wondering if its stripped the timing cog or jumped a tooth or two
_________________ Skidz are cooooool!
|
|||
| Top | |
|||
| EL___Fairmont |
|
|||
|
henry95ef wrote: hey guys my ef falcon has been coughing and spluttering for a few weeks, some times completely stalling, i replaced the fuel filter and it went great for a day or so, i checked and wasn't getting any spark so i replaced the coil pack still no spark, i'm getting power to the coil pack but nothing after..................... Need ideas guys as i've missed a days work already so far trying to figure this out Power to the coil pack doesn't mean s**t. 4pin connector from memory, 1 will be battery voltage the other 3 are earth reference triggered by the ECU. Check the other 3 wires first to make sure your getting the earth trigger from the ecu while cranking...
_________________ Current ride 2007 |
|||
| Top | |
|||
| henry95ef |
|
|||
|
ok so i just pulled the crank angle sensor off and found it half rubbed thru from the serpentine belt and bits of belt wrapped around the crank trigger........ could this be the cause of my dramas?
_________________ Skidz are cooooool!
|
|||
| Top | |
|||
| henry95ef |
|
|||
|
ok so i replaced the crank angle sensor still no start, ok so how do i check the coil wires?
do i run the test light to positive or negative as they are supposed to receive an earth signal from the ecu? kinda over trying to figure this out any ideas would be appreciated
_________________ Skidz are cooooool!
|
|||
| Top | |
|||
| mendyxr6 |
|
|||
|
i had cam chain noise which was due to one of the plastic tensioners breaking and dropping down, the chain was rubbing on the timing case.
its a pain in the buttocks to change aswell
_________________ kangaroos and radiators are a bad mixture |
|||
| Top | |
|||
| henry95ef |
|
|||
|
yeah i picked up another motor real cheap instead of fixing my timing chain noise but no point putting it in til i get this one running
come on guys any ideas? i've used the search on here and found a few ideas which didnt help
_________________ Skidz are cooooool!
|
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 113 guests |
