|
| payaya |
|
||
|
Hey,
What size is this nut? I thought it was 32mm but it was way too big. Thanks |
||
| Top | |
||
| my98xh |
|
|||
|
Its 30mm i believe
_________________ 2007 BF MKII XR6T 6 spd Manual, Bionic Blue |
|||
| Top | |
|||
| phongus |
|
|||
|
If you're talking about the front bearing retaining nut, then it's a 29mm nut. Needs to be tightened while you rotate the disc to 30Nm, then undo the nut half a turn and then tighten to 4Nm (I do this by feel...usually only hand tight without a T-bar or ratchet).
_________________ phongus = Post whore 2006 |
|||
| Top | |
|||
| shyun |
|
|||
|
phongus wrote: If you're talking about the front bearing retaining nut, then it's a 29mm nut. Needs to be tightened while you rotate the disc to 30Nm, then undo the nut half a turn and then tighten to 4Nm (I do this by feel...usually only hand tight without a T-bar or ratchet). I did mine to 5nm yet everywhere i've read it says 1.5nm. 1.5nm the disk wobbled slightly when you pull on it outwards.
_________________ ED XR6, LeMans Red, 5-Speed |
|||
| Top | |
|||
| phongus |
|
|||
|
shyun wrote: phongus wrote: If you're talking about the front bearing retaining nut, then it's a 29mm nut. Needs to be tightened while you rotate the disc to 30Nm, then undo the nut half a turn and then tighten to 4Nm (I do this by feel...usually only hand tight without a T-bar or ratchet). I did mine to 5nm yet everywhere i've read it says 1.5nm. 1.5nm the disk wobbled slightly when you pull on it outwards. 1.5Nm is like finger tight...I didn't like finger tight so I do it hand tight. I think if it is anything more, the bearings will wear out faster and more road noise.
_________________ phongus = Post whore 2006 |
|||
| Top | |
|||
| payaya |
|
||
|
Yep did the 30nm, then finger tight. You believe I should a bit tighter?
How would I know if it should be tighter? Also should I leave the standard inner wheel dust covers on or off? Also what causes the suspension to sort of squeak down going over bumps? I saw the lower ball joint had a broken boot? Would this cause it? Can I replace the boot or would the ball joint be required to be replaced? |
||
| Top | |
||
| shyun |
|
|||
|
Hold both sides of the disk and rock/shake it back and forth. It shouldn't have any play in it. i did 5nm on my car and there was no movement so i'd do that if you have a torque wrench.
My car squeaks over bumps because of the upper arm bushes so it might be that...
_________________ ED XR6, LeMans Red, 5-Speed |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 242 guests |
