|
elmattxr |
|
|||
|
i have a ef xr parts car,now i want to put the lsd xr diff in my el fairmont.now should i just swap the centre and tailshaft? or change the lot over.
thanks in advance matt
_________________ JUST LIKE A MIDGET AT A URINAL, I BEST BE ON MY TOES |
|||
Top | |
bry40l |
|
|||
|
Pretty sure the centre will just swap over
_________________ BF XR6 |
|||
Top | |
Johnson stroker |
|
|||
|
just swap the lot, piece of mcake to pull out and put another one in, cleaner too. before you put it in, change the oil in the diff though.
much easier than the root around of swapping a centre. there is alot more involved in swapping a centre than there is in doing a complete diff and drive shaft swap. for the untrained in the ways of diffs you should be able to complete this in well under ½ a day. a centre swap, good bye weekend, hello frustration. cost alot more too as you will be bearings and what not along the way with a centre swap, then hoping you have the shims on hand in the correct size..
_________________
|
|||
Top | |
Johnson stroker |
|
|||
|
bry40l wrote: Pretty sure the centre will just swap over Not without also swapping the pinnon as well, dropping the axles and so on. everything needs to come apart just to swap a centre.
_________________
|
|||
Top | |
bry40l |
|
|||
|
Ahhk yeah f**k playin around with thst then, I thought it would be simple
_________________ BF XR6 |
|||
Top | |
snap0964 |
|
|||
|
You'll most likely need a diff spreader to get the centre out - although some have said previously that the centre just comes out.
_________________ 96 XH Longreach 'S': LPG, Alarm, 3.23:1 LSD, Cruise, Trip Comp, ABS, Power Windows, Mid Series Dome Lt, Climate Ctrl |
|||
Top | |
Krytox |
|
|||
|
EL housing is better, It has revised upper control arms.
As above you can replace just the centre, however you may get noise as the centre has not been set to the housing. I've replaced heaps of centres into non lsd diffs, and never had an issue. But if you go down the entire diff route, (reccomended) you need to change hand brake cables and upper mounts.
_________________ Carefree, we may not be number one, but we're up there. |
|||
Top | |
Matt_jew |
|
||
|
bry40l wrote: Ahhk yeah f**k playin around with thst then, I thought it would be simple Its great that you are on here and learning but may I recommend that if you dont know the answer 100% due to inexperience that you dont give advice? Watch , learn and ask questions and you will be up with it in no time.
_________________ xr6turnip wrote: More people paid for a ride in a VT commodore then an AU Falcon so the VT is superior.
Based on that fact my Mum is the best around! |
||
Top | |
jaysway |
|
|||
|
whole diff swap is easier.
|
|||
Top | |
elmattxr |
|
|||
|
cheers guys. yeah i figure just to swap the lot is easier.but keen to know more about the differences in the top arms?? im not looking to mod this car its just my daily hack fairmont that i want the lsd diff and t5 slushy in it to wake it up a bit
_________________ JUST LIKE A MIDGET AT A URINAL, I BEST BE ON MY TOES |
|||
Top | |
fairlane6970 |
|
|||
|
Must be easy I did it!
_________________
|
|||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 254 guests |