How do program the remote key pad from Au1

Hope this all helps

For AUI (Smartlock Models - 2 Button Remotes)
Up to four Keypads can be programmed and used with the Smartlock Remote Central locking system.
If you have replaced the BEM, or new keypads are being added to the system, you will need to train the keypad codes to the module.

1. The ignition switch should be in the Off position, with all the doors shut and Unlocked.
2. Turn the ignition key to the ACCESSORY position and within 5 seconds, operates the rear demister switch exactly three times in quick succession. (IE. Press the switch so the Demister light turns on, then off, then back on again.)
3. After the 5 seconds is up, the door locks will change state, to indicate that the BEM has entered keypad learn mode.
NOTE : All existing keypads at this point, have been erased from memory !
4. Press either buttons on the keypad that is to be trained. The door locks will change state twice, to indicate that the keypad has been added to the BEM memory.
5. Follow step 4. for each keypad that is to be added to the BEM memory. A maximum of 4 keypads can be added to the BEM memory.NOTE : You must teach all remote keypads for the Smartlock module, before proceeding.
6. When you have thought all the remote keypads, turn the ignition to the Off position to leave the learn mode. The door locks will change state to indicate a return to normal mode.
7. Check the function of both buttons on each keypad, to ensure that the keypad has been trained.



For AUI - Late Series (Smartsheild Models, 4 Button Remotes)
Up to four Keypads can be programed and used with the Smartsheild Remote Central locking system.
If you have replaced the BEM, or new keypads are being added to the system, you will need to train the keypad codes to the module.

1. The ignition switch should be in the Off position, with all the doors shut and Unlocked.
2. Turn the ignition key to the ACCESSORY position and within 5 seconds, operates the rear demister switch exactly three times in quick succession. (IE. Press the switch so the Demister light turns on, then off, then back on again.)
3. After the 5 seconds is up, the door locks will change state, to indicate that the BEM has entered keypad learn mode.
NOTE : All existing keypads at this point, have been erased from memory !
4. Press either buttons on the keypad that is to be trained. The door locks will change state twice, to indicate that the keypad has been added to the BEM memory.
5. Follow step 4. for each keypad that is to be added to the BEM memory. A maximum of 4 keypads can be added to the BEM memory. NOTE : You must teach all remote keypads for the Smartsheild module, before proceeding.
6. When you have taught all the remote keypads, turn the ignition to the Off position to leave the learn mode. The door locks will change state to indicate a return to normal mode.
7. Check the function of all buttons on each keypad, to ensure that the keypad has been trained.

ok, done all that everything work to plan but not able to control the doors by the keypads ive replaced the batteries also noticed no flashing led on the dash I've not long acquired this vehicle

No flashing LED ????? You mean the smartlock LED ????

Hrmmm... I dont know a lot about the AU models, but check the Central Lock Fuse...
Does the Central Locking work at all ????
Also does your interior Lamp work ? (On EF/EL, part of the Smartlock Power comes from the interior Lamp fuse... If this fuse is blown, then the Smartlock Lamp will not flash... Hence the question)....

Yeh the central locking works fine by the key not the pad, the interior light works aswell looks like a visit to the local Ford dealer to rip me off blind
thanks for the help

Is it the same for the E series Matti?