So I was wiring in my new starter button (I know it's pointless, but I like it)... and when I was putting the steering column surround back on, I blew a fues... not sure how, but it was one of the ignition fuses (top left)... so I swapped the airbag fuse in so the car would start, then the next morning I replaced the fuse... airbag light stays on.... So I read the airbag thread sticky on here and tried to reset the light by connecting the 4th pin from the top left in the diagnostics plug, to the one in the bottom left.... can't seem to get any beeps or anything? Is there a time I have to do this, or do I have to hold the wire there for a long time? Any special type of wire I have to use even maybe?

Or does this mean that there is actually a fault with the airbags if I can't get it to beep and reset the code?

No one has any ideas?

my mate did this when he borrowed my el he took airbag fuse out to replace the blown one, with no fuse in the airbag one the airbag module see's theres a fault in the system there for brings the light on to remove the light u need to see a auto sparky or someone with a scan tool they go throu the car settings and reset it only take about 10min approx.