|
| Nathanhrv |
|
||
|
Hey guys just wondering what is the easiest way to access the spark leads to change them on an EL as its in a bit*h of a spot. Thanks for any replies guys
|
||
| Top | |
||
| Esteven8 |
|
|||
|
Remove the airbox and intake pipes, makes it a hell of a lot easier. It's still a s**t place to get at though.
_________________ dc_todd wrote: Cheap pads squeal like cheap hookers, and you can take that to the bank. Au Fairmont Ghia My (Old) 95 EF Wagon |
|||
| Top | |
|||
| 66 coupe |
|
||
|
remove the airbox that will make it a lot easier
|
||
| Top | |
||
| Gab1 |
|
|||
|
I remove the airbox AND the fans, removing the fans gives HEAPS more room
Gab |
|||
| Top | |
|||
| Nathanhrv |
|
||
|
thanks guys ill give that a try, and let yas no how i go
cheers |
||
| Top | |
||
| phongus |
|
|||
|
To get the leads onto the distributor cap, I tend to use the handle end of a screwdriver through the top to lock the boots onto the nipples if you can't push down on them from underneath.
_________________ phongus = Post whore 2006 |
|||
| Top | |
|||
| 87SIlude |
|
||
|
Llike said remove intake piping and air box. Go at them from underneath the manifold, not by trying to sqeeze you're hand through the manifold. It'll get stuck haha.
Once you get the angle its quite easy. Do one lead at a time so you don't stuff up the firing order. |
||
| Top | |
||
| Esteven8 |
|
|||
|
87SIlude wrote: Do one lead at a time so you don't stuff up the firing order. +1 I forgot to mention that in my earlier post, you definitely don't want to spend more time than necessary doing this job. As far as routine maintenance goes, it's my opinion that replacing leads on these cars is the worst job to have to do.
_________________ dc_todd wrote: Cheap pads squeal like cheap hookers, and you can take that to the bank. Au Fairmont Ghia My (Old) 95 EF Wagon |
|||
| Top | |
|||
| 66 coupe |
|
||
|
take all the leads off the cap (its not that hard, just mark where no 1 is and sort the firing order from there) reason being, while leads are off, remove the cap and inspect it and the rotor, usually the carbon centre pin in the cap wear out and is often overlooked
|
||
| Top | |
||
| phongus |
|
|||
|
66 coupe wrote: take all the leads off the cap (its not that hard, just mark where no 1 is and sort the firing order from there) reason being, while leads are off, remove the cap and inspect it and the rotor, usually the carbon centre pin in the cap wear out and is often overlooked or missing which was my case. 87SIlude wrote: Llike said remove intake piping and air box. Go at them from underneath the manifold, not by trying to sqeeze you're hand through the manifold. It'll get stuck haha. Once you get the angle its quite easy. Do one lead at a time so you don't stuff up the firing order. Even when I get at it from underneath, I tend to use the handle of the screwdriver to push it down to make sure it has actually clipped on. I don't take the intake out either sometimes...perks of having long and skinny hands.
_________________ phongus = Post whore 2006 |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: Google Adsense [Bot], Kempy and 62 guests |
