|
| ef_falcon_95 |
|
|||
|
Cheers mate.
I think I know why I can't find the plug. Would swapping over to a fairmont ghia dash loom have anything to do with it? As they have 2 airbags . Anyone ??
_________________ El XR6 Turbo |
|||
| Top | |
|||
| Mitch_ |
|
|||
Posts: 6168 Joined: 5th Nov 2004 |
need to install a resistor where the 2nd airbag would be...
_________________
|
|||
| Top | |
|||
| ef_falcon_95 |
|
|||
|
Mitch_ wrote: need to install a resistor where the 2nd airbag would be... Where on the dash loom is that ? I hope I don't have to remove the dash again 
_________________ El XR6 Turbo |
|||
| Top | |
|||
| Mitch_ |
|
|||
Posts: 6168 Joined: 5th Nov 2004 |
in all honesty I can't remember if you will need to or not - i have an EF loom sitting here but its series one so i doubt it has the resistor in it...
_________________
|
|||
| Top | |
|||
| Mitch_ |
|
|||
Posts: 6168 Joined: 5th Nov 2004 |
my loom doesn't - but it is where the airbag would normally be
 so have fun with that!you might be able to access it from glovebox if you're lucky i guess... Should've got a EF Series 1 Loom!
_________________
|
|||
| Top | |
|||
| ef_falcon_95 |
|
|||
|
what does the plug look like?? i cant remember there being a stray plug around the glove box area. unless its the one up behind the fuse box ??
_________________ El XR6 Turbo |
|||
| Top | |
|||
| Marty's xr |
|
||
|
Wow man, this sounds like its been a massive effort!! Well done
 By the way, when you want to regas your air con let me know, I can do it for you 
_________________
|
||
| Top | |
||
| ef_falcon_95 |
|
|||
|
Cheers mate. It was a tough job for my first attempt , but in the end was a great result .
If u can do it for me that be great . I'm looking to get it regassed soon.
_________________ El XR6 Turbo |
|||
| Top | |
|||
| Benjii |
|
||
|
wee bit of a thread mine :O but it relates to a similar problem I'm having with my c/c conversion in my GLi I get the E2 error and was hoping somone could tell me which pins are the ones to use to jump start the blend door motor. Otherwise I'll have to pull the dash out (ergghh) and change the blend door motor for another which I'd rather not do if I can get away with it lol
|
||
| Top | |
||
| ef_falcon_95 |
|
|||
|
Hi mate
I had the same issue as you . I got the error code. So I ripped out the dash for the 2nd time and Probed a 12v battery into the blend door pins to jump start it. I opened it,closed it. But dash back in and it worked fine, no more error. Im pretty sure if you take of the C/C module and unplug the wire harness that goes into it you can jump start it by probing at the pins. Not sure which pins . You can find out if you have a wiring diagram of the C/C.it'll be in a workshop manual .
_________________ El XR6 Turbo |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 132 guests |
