|
| jamie22_cole |
|
|||
|
is there a correct procedure to bleeding the brakes an EL XR6?
|
|||
| Top | |
|||
| kwaussiekid |
|
||
|
Start with the wheel furthest from brake cylinder. In other words, back left, then back right, front left and finally front right.
_________________ The older I get the better I was! |
||
| Top | |
||
| Johnson stroker |
|
|||
|
Yes.
Passenger rear, Drivers rear, Passenger front, drivers front. Don't go stupid either, you are bleeding brakes not trying to crack your master cylinder.
_________________
|
|||
| Top | |
|||
| jamie22_cole |
|
|||
|
thanks guys
|
|||
| Top | |
|||
| gusbus |
|
||
|
{USERNAME} wrote: Yes. Passenger rear, Drivers rear, Passenger front, drivers front. Don't go stupid either, you are bleeding brakes not trying to crack your master cylinder. it'd have abs though wouldnt it so it would be driver rear, passenger rear, driver front, passenger front |
||
| Top | |
||
| kwaussiekid |
|
||
|
ABS,doesn't affect the way to do it.
_________________ The older I get the better I was! |
||
| Top | |
||
| cjh |
|
||||||
|
Check all the caliper slides too, and condition of the slide boots, piston dust boots, etc.
_________________ http://youtu.be/jJTh9F3Vgg0 |
||||||
| Top | |
||||||
| bry40l |
|
|||
|
gee i thought my brake fluid was dirty before i changed it
_________________ BF XR6 |
|||
| Top | |
|||
| jamie22_cole |
|
|||
|
how did ya get the fluid tank so clean?
|
|||
| Top | |
|||
| cjh |
|
|||
|
{USERNAME} wrote: how did ya get the fluid tank so clean? I removed the res from the master.....there is a little bolt underneath....8mm I think.....doesn't need to be done up tight either....it is a "shouldered" bolt.....so it doesn't actually clamp down on the res.....have a look with a little mirror-on-a-stick and you'll see what I mean.
_________________ http://youtu.be/jJTh9F3Vgg0 |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 42 guests |
