|
| Deano_XH |
|
||
|
gday guys
got a mates bravo/courier on gas running like crap, bad economy even worse power, has just had fresh plugs still just the same i have driven other bravos on gas same motor and they seem a lot better all info is appretiated 
|
||
| Top | |
||
| tickford_6 |
|
||
Posts: 6449 Joined: 11th Nov 2004 |
get the gas tuned. come to think of it, that engine commonly burns exhaust valves.
But get it looked at by some one that knows what they are doing. |
||
| Top | |
||
| Deano_XH |
|
||
|
ok but what do u mean by burns tthe exaust valves and how do u check it? cheers
|
||
| Top | |
||
| tickford_6 |
|
||
Posts: 6449 Joined: 11th Nov 2004 |
It will show up as low compression on the effected cylinders.
A leak down test would show you where there is any major leakage. Still the first step is get the gas tuned and make sure the mixer is not under sized. |
||
| Top | |
||
| alfy |
|
|||
|
is it a 4G64 motor or a G6?
_________________ 2021 V6 Manual Amarok - 245kw/750nm - many goodies |
|||
| Top | |
|||
| Deano_XH |
|
||
|
as far as iknow its a g6 motor but if it helps its a mazda bravo 1997 b2600.injected factory duel fuel
|
||
| Top | |
||
| Jeremy BA |
|
|||
Age: 51 Posts: 85 Joined: 10th Nov 2010 Ride: Ford BA FUTURA 2002Ded Gas Wagon Location: FRANKSTON |
Tickford 6 is correct
 , we had 3 of them as company vehicles, it got to the point where they were running at idle like they had a top fueler cam in them  . Would shake the whole car on its springs  . Funniest thing was that idle on a hot day with the AC on, you would be driving along and the Ac would be Cool then when you pulled up at the lights it would start pumping hot air like the heater was on . It was hilarious, (mainly because I didnt have to drive them day in and out ) All 3 of them needed rebuilt heads after 100,000 k's seats were f**k in all of them. 
_________________ I'm constantly surrounded by IDIOTS!! |
|||
| Top | |
|||
| Deano_XH |
|
||
|
haha what a pisser thanks for the help guys might just have to tune it the sell the bloody thing so hes not stuck with a half decent in. need of a top end rebuild cheers
|
||
| Top | |
||
| cjh |
|
|||
|
They are also known for sticking oil pressure relief valves....either full open or full shut.
Full open, they would rattle their heads off, and full shut, would blow the seal out on the oil filter. The 94 models would blow the alloy plugs out of the head under the cam, and fill the sump with coolant......was a recall on them......had to add more punch marks ( peen ) around the plugs as well as puting Loctite 290 Super Wick-in around them too.
_________________ http://youtu.be/jJTh9F3Vgg0 |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 13 guests |
