|
| greg302 |
|
||
|
wat about tweecer negood?
_________________ 347, crane cam, Pro topline 180 heads, Edelbrock victor efi intake, 80mm C&L maf, 75mm tb, 30lb injectors and 1/4 horse |
||
| Top | |
||
| nannas_ed |
|
|||
|
greg302 wrote: wat about tweecer negood?
tweecer good no car run not.
_________________
|
|||
| Top | |
|||
| EDXR8 |
|
|||
|
Tweecer is excellent but there aren't many aussie EECs that are supported by the tweecer yet. If your EEC is supported you basically get full tunability and retain the advantages of the factory sequential injection, MAF load sensing and open/closed loop system which is usually only available on high proced aftermarket systems.
|
|||
| Top | |
|||
| Bassfreak55 |
|
||
|
EDXR8 wrote: Tweecer is excellent but there aren't many aussie EECs that are supported by the tweecer yet. If your EEC is supported you basically get full tunability and retain the advantages of the factory sequential injection, MAF load sensing and open/closed loop system which is usually only available on high proced aftermarket systems.
It the EF/EL EEC-V supported by the tweecer as yet? Its been 'in progress' for ages ay!
|
||
| Top | |
||
| EDXR8 |
|
|||
|
I think EL has some initial basic support.
|
|||
| Top | |
|||
| Bassfreak55 |
|
||
|
EDXR8 wrote: I think EL has some initial basic support.
Good stuff. Who would i get in contact to find out in more details? |
||
| Top | |
||
| greg302 |
|
||
|
Peter Bysterveld 0419922959 ('http://www.icenet.com.au/~pie/');
_________________ 347, crane cam, Pro topline 180 heads, Edelbrock victor efi intake, 80mm C&L maf, 75mm tb, 30lb injectors and 1/4 horse |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 19 guests |
