|
| NUTZEF |
|
||
|
long time and no posts i know but its now time to rebuild my ef 4l donk as its blowing smoke.
pulled down the moter today and bores and rods look good as do the bearing but as for pistons and rings are a real mess. my question is should i try find standerd bore pistons or bite the bullit and go 20 thou over bore. acl only sell 20 thou for what i have seen. i will just be running standerd internals with 10 psi as my experience to date has been fine. cheers.
_________________ WOLF V500, t66(ar70 compressor), rochester 550cc injectors, borgg 265l fuel pump, 48mm turbosmart gate, turbosmart plumb back bov, 600x300x100 cooler, 3 inch zorst , 3.45 lsd, xr6 head, wade 1604 cam, adjustable cam gear, K&N pod filter, on 10psi and manual convertion exedy button clutch. 285.6rwkw |
||
| Top | |
||
| JayEdXr6 |
|
||
|
Ring up ACL there site is hopeless. Probably good idea to go over bore and hone only like 30 buks a pot
_________________ Poly green Ed xr6-new n/a motor on the way. |
||
| Top | |
||
| xhfalcon |
|
|||
|
ACL rebuild will be fine for 10 psi
chuck on a permaseal 1.3mm head gasket if you plan on upping the boost in the future Spool rods and CP pistons can be had pretty cheap thats what ill be doing when the time comes however ACL gear will be fine if your on a budget
_________________ XH falcon, GT3582, tuned length manifold, turbosmart 48mm gate, 3inch stainless exhaust, Ported head, Custom grind surecam, turbosmart fpr800, deatch werks 300lph fuel pump, siemens 60lb injectors. Turbo smart vee port BOV. microtech lt10. |
|||
| Top | |
|||
| EBXR8380 |
|
|||
|
Yep just gap the ring end clearance a little more..
_________________ As in ZOOM 126 edition |
|||
| Top | |
|||
| NUTZEF |
|
||
|
Ok so finished rebuild used hypatec pistons, hastings rings and bearings. I used standerd piston size and did not go overbore as the bores was in good condition. used an au gasket and genuine head bolts. motor back in now and sounds sweet will be changing the 1.32 exhaust housing to a 0.96 and retuning with 12psi. will put some pics up soon. (EBXR ring gap was 0.45mm )
_________________ WOLF V500, t66(ar70 compressor), rochester 550cc injectors, borgg 265l fuel pump, 48mm turbosmart gate, turbosmart plumb back bov, 600x300x100 cooler, 3 inch zorst , 3.45 lsd, xr6 head, wade 1604 cam, adjustable cam gear, K&N pod filter, on 10psi and manual convertion exedy button clutch. 285.6rwkw |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 20 guests |
