|
| teeroy |
|
|||
|
teeroy wrote: cheers, last thing to sort out is loom and that small shoulder bolt plate, still unsire if needing one or two. and if one, should it have wear marks? if not i'll just cut and punch a bit of steel at work, lol. picking up ecu tonight so just trying to get an answer on the wear plate question for tomorrow when it all goes in.
_________________ be good or be good at it. |
|||
| Top | |
|||
| cjh |
|
|||
|
teeroy wrote: teeroy wrote: cheers, last thing to sort out is loom and that small shoulder bolt plate, still unsire if needing one or two. and if one, should it have wear marks? if not i'll just cut and punch a bit of steel at work, lol. picking up ecu tonight so just trying to get an answer on the wear plate question for tomorrow when it all goes in. You only need 1 plate.....a new shoulder bolt wouldn't hurt either.
_________________ http://youtu.be/jJTh9F3Vgg0 |
|||
| Top | |
|||
| teeroy |
|
|||
|
all in all running, is drivable although very tempermental, starts revving at about 2g for 30 odd seconds, and unfortunately the box is noisy, although is eaither ea-eb box so what can ya do.
also runs terribly on petrol. either way it's going into the mechanics tomorrow just for safe measure and so he can work out any little kinks, plus i need a standard rear shock and spring setup as my back is stupid low.
_________________ be good or be good at it. |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 64 guests |
